Cobra MR HH475 FLT BT MRHH475_MANL_ENG - Page 24

Mobile Phone Operation With Bluetooth® VOHpFerMatainrigneYoRuardRioadPirootocols Using Voice Dial This feature allows you to use your voice to dial a contact from the contact list on your mobile phone. NOTE Voice dialing is an advanced function and may not be supported by all phones. Cobra suggests you set it up and become familiar with it on your mobile phone before you attempt using it in conjunction with the HH475 or another Bluetooth device. This is an advanced function and not all mobile phone combinations will be successful. Some allow you to set pre-recorded contacts. Some advanced phones have active voice recognition and match your mobile phone's contact list. Initiating a Voice Dial Call Connecting a Voice Dial Call To Initiate a Voice Dial Call: 1. Press and release the Bluetooth button to get into the Bluetooth Standby mode. 2. Press and release the Bluetooth button twice (2x) from Bluetooth Standby mode. This will initiate the voice dial feature on the paired mobile phone. 3. You will hear a beep or audio command from the phone. Press and hold the PTT (Push to Talk) button and speak the name into the HH475. 4. The mobile phone will begin to dial the contact it "recognizes." The call will be complete through the speaker and microphone of the HH475. You will see the "diaLng" and "Connct" screens as the call is completed. 5. Hang up by pressing the Bluetooth button when you complete your call. Mobile Phone Operation With Bluetooth® VOHpFerMatainrigneYoRuardRioadPirootocols Last Number Redial This feature allows you to redial the last number stored in the mobile phone's internal Call Log. This feature is supported by most mobile phones. Bluetooth Button To Initiate a Last Number Redial: 1. Press and release the Bluetooth button to get into the Bluetooth Standby mode. 2. From Bluetooth Standby, press and hold the Bluetooth button for two (2) seconds [until the radio beeps two (2) times]. 3. The paired mobile phone will redial the last number. The call will be complete through the speaker and microphone of the HH475. 4. Hang up by pressing the Bluetooth button when you complete your call. Bluetooth Standby Mode, Unpaired State Bluetooth Standby Mode, Paired State To End Pairing (At the End of the Day) You might not want to take your calls through this VHF radio once you are back at the dock or in a dry location. See the instructions in the Bluetooth Mode Programming section on page 23 for instructions on how to Turn OFF the Bluetooth function of the HH475. The "p" will disappear from the Bluetooth Standby screen. NOTE If switched to OFF setting, then the HH475 will not reconnect with mobile phone on power up. It must be turned back ON again from the Bluetooth Programming mode. 42 English Nothing Comes Close to a Cobra® 43