Cobra MR HH450 DUAL MR HH450 Dual - English - Page 12

Wrist Strap and Belt Clip, Batteries and Charger

Page 12 highlights

VInHsFtaMllaatriionne Radio Protocols Wrist Strap and Belt Clip Wrist Strap and Belt Clip • Belt Clip Belt Clip Use the spring-loaded belt clip to carry the radio on your person. 1. Slide the belt clip into the guide channel on the back of the radio until it is locked in place. Insert Belt Clip onto Radio 2. To attach the wrist strap, insert it through the hole at the top of the belt clip, feed it through the looped end and pull tight to secure to the belt clip. 3. Press open the belt clip, slide it over the belt and release the clip. 4. To remove the belt clip from the radio press the tab on the belt clip, which unlocks the clip, and slide it out. Wrist Strap Attachment Secure Radio ATIS VOX TRX ROG VGHMFRS A BUIC HI SAMEMEM SCAN H 18 English Batteries and Charger VInHsFtaMllaatriionne Radio Protocols Power Sources Initial Battery Charge Initial Charge The Cobra-provided LiON battery pack may be charged at home, in a car or in a boat using the appropriate 12V or 120V power cord with the charger. 1. Insert one (1) of the power cords into the back of the drop-in charger. 2. Insert the other end of the power cord into the appropriate 12V or 120V power source. 3. Remove battery pack spacer from the charger and insert the entire radio/battery into the charger. The metal charge contacts on the battery will contact the mating prongs in the charger to transfer the charging current. 4. Observe that the red light on the front of the charger glows to indicate that the battery pack is properly seated and the charger is operating. 5. Allow the batteries to charge for five (5) to six (6) hours before use. The light will change back to green when the battery is fully charged. WARNING Only the rechargeable LiON battery pack can be recharged. You MUST use one of the charging devices provided with this radio. Do not substitute any other type of charging adapter or charger base for this radio. Battery damage, fire or explosion may result. It is equally important to prevent the lithium-ion (LiON) battery pack from freezing to obtain best performance from the battery pack. NOTE If the drop-in charger is used on a boat, Cobra recommends you attach it to a horizontal shelf or vertical bulkhead (using the screw holes provided) to prevent possible damage due to the boat rolling or pitching. The charging base has been designed to hold the battery pack in place during rough sea conditions. Nothing Comes Close to a Cobra® 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44

19
Nothing
Comes Close to a Cobra
®
Belt Clip
Insert Belt Clip onto Radio
A
B
C
I
U
Secure Radio
Installation
18
English
Installation
Wrist Strap and Belt Clip
Belt Clip
Use the spring-loaded belt clip to carry the radio on your
person.
1.
Slide the belt clip into the guide channel on the back of the
radio until it is locked in place.
2.
To attach the wrist strap, insert it through the hole at the
top of the belt clip, feed it through the looped end and pull
tight to secure to the belt clip.
3.
Press open the belt clip, slide it over the belt and release
the clip.
4.
To remove the belt clip from the radio press the tab on the
belt clip, which unlocks the clip, and slide it out.
Wrist Strap Attachment
Wrist Strap and Belt Clip
Batteries and Charger
Initial Charge
The Cobra-provided LiON battery pack may be charged at
home, in a car or in a boat using the appropriate 12V or
120V power cord with the charger.
1.
Insert one (1) of the power cords into the back of the
drop-in charger.
2.
Insert the other end of the power cord into the appropriate
12V or 120V power source.
3.
Remove battery pack spacer from the charger and insert
the entire radio/battery into the charger. The metal charge
contacts on the battery will contact the mating prongs in
the charger to transfer the charging current.
4.
Observe that the red light on the front of the charger
glows to indicate that the battery pack is properly seated
and the charger is operating.
5.
Allow the batteries to charge for five (5) to six (6) hours
before use. The light will change back to green when the
battery is fully charged.
WARNING
Only the rechargeable LiON battery pack can be
recharged. You MUST use one of the charging devices
provided with this radio. Do not substitute any other
type of charging adapter or charger base for this
radio. Battery damage, fire or explosion may result.
It is equally important to prevent the lithium-ion
(LiON) battery pack from freezing to obtain best
performance from the battery pack.
NOTE
If the drop-in charger is used on a boat, Cobra
recommends you attach it to a horizontal shelf or
vertical bulkhead (using the screw holes provided)
to prevent possible damage due to the boat rolling or
pitching. The charging base has been designed to hold
the battery pack in place during rough sea conditions.
Power Sources
Initial Battery Charge