Cobra MR HH125 MRHH125_MANL_ENG_C - Page 14

Advanced Operation VOHpFerMatainrignYeoRuardRioadPiorotocols Dual-Watch Mode Dual-Watch mode gives you one (1) button access to scan a total of two (2) channels of most importance to you. Channel 16 is preprogrammed and will always be one (1) of the scanned locations. The other channel can be any marine VHF channel of your choice. DUAL-WATCH Button Dual-Watch Scan Mode Using Dual-Watch 1. In Marine Standby mode, select the desired channel for Dual-Watch scanning. 2. Press the Dual-Watch button. The DW icon will appear on the LCD display and the radio will scan channel 16 and the selected channel. 3. A signal on any one (1) of the two (2) channels will stop the scan for 10 seconds to allow you to listen to the traffic on that location. NOTE After the Dual-Watch scan stops to monitor a channel, as long as you do not press any buttons within 10 seconds, your radio will automatically resume scanning the Dual-Watch channels. 4. Press the Channel Up or Channel Down buttons to resume scanning the Dual-Watch channels or to change the scan direction. 5. To EXIT the Dual-Watch scan, press the Dual-Watch button again. The DW icon will disappear from the LCD and the radio will return to Marine Standby mode. Advanced Operation VOHpFerMatainrignYeoRuardRioadPiorotocols Memory Location Mode Your radio has ten (10) memory locations (numbered 0 to 9) for your most frequently used channels. These memory locations can be selected individually or can be scanned. MEM/ESC Button Memory Location Number Channel Up/Down Buttons To enter Memory mode, press Memory/Escape button. The display will show the MEM icon and the Memory Channel bank will be activated and displayed. To Program Memory Locations: 1. Press and hold the Memory/Escape button for two (2) seconds. The memory location number will start flashing and the MEM icon will be turned On. 2. Use the Channel Up and Channel Down buttons to advance to the memory location (0-9) you want to program. 3. Press the Memory/Escape button to select the memory location. The memory channel number will stop flashing and the channel number will start flashing. 4. Use the Channel Up and Channel Down buttons to change to the channel you want to store into the selected memory location. 5. Press the Memory/Escape button to program that channel. The memory location number will flash again. Channel Number Repeat steps 2 through 5 to program as many additional memory locations as you want [up to ten (10) VHF memory channels]. 6. Press and hold the Memory/Escape button for two (2) seconds. This will return the radio to Memory mode. 7. Press and release the Memory/Escape button again to return to Marine Standby mode. 22 English Nothing Comes Close to a Cobra® 23