Celestron NexStar Evolution 6 Telescope NexStar Evolution - Page 18

NEXSTAR EVOLUTION TELESCOPE SETTINGS IN NEXSTAR+ HAND CONTROL Press Menu, scroll to the "Peripherals" menu and press ENTER. Here, you can control L.E.D. brightness of the logo lights and accessory tray lighting, check the battery status, or set more advanced features including external power supply and USB charge port settings. ADJUST THE L.E.D. BRIGHTNESS 1. Scroll to "Mount Lights" and press ENTER. 2. Scroll to select Tray Light, WiFi Light, or Logo Light and press ENTER. 3. Select a brightness value from 0-10, 0 being OFF, and 10 being fully lit. Press ENTER and the new brightness setting will take effect. POWER 1. Scroll to "Power" and press ENTER. 2. Scroll to select "Status" or "External Power" and press ENTER. • Status will display the battery voltage, if the battery charge state is High, Medium, or Low, and if the battery is charging or discharging. • External Power allows you to select a higher input current if you are using a higher capacity power supply. Values can be between 2 and 5 amperes as specified on your power supply. Do not change this setting unless you are using a larger capacity supply. The included power supply should always be set to 2.0A. WIFI 1. Scroll to "WiFi" and press ENTER. 2. Scroll to select "Status" or "Enable/Disable" and press ENTER • Status will display the WiFi mode, Direct Connect or Access Point, and whether or not the WiFi is connected to a network. • Enable/Disable will optionally allow you to disable the WiFi broadcast. The WiFi L.E.D. will shut off indicating it has been disabled. Every time you power off and on the mount again, this setting defaults to Enabled. USB CHARGE PORT 1. Scroll to "Charge Port" and press ENTER. 2. Press ENTER to toggle between "Automatic" or "Always On". "Always On" keeps the charge port going, even in a low battery condition. "Automatic" automatically disables the USB Charge Port when battery power is low. 18 I ENGLISH