Carvin FX1644 Instruction Manual - Page 53

FX44 TECHNICAL SPECIFICATIONS Frequency Response Mic Input Connector: 3-pin XLR type Mic or line inputs to Input impedance: 3k ohms (balanced) two-track output: 20 Hz-20k H 1dB Source impedance: nominal 'low impedance' Total Harmonic Distortion (50 ohms to 1k ohms) Mic in to two-track out Nominal input range: -70 to -10 dBv (.3mV to 300mV) 40 dB gain Maximum input level: +10 dBv (3.3V) +10dBv output, 20-20kHz: less than .1% Line Input Connector: One 1/4' phone jack typical 1kHz THD: less than .03% Input impedance: 22k ohms Line in to two-track out Nominal input range: -20 dBv to +10 dBv (100mV to 10 dB gain Maximum input level: +30 dBv (30V) +10dBv output, 20-20kHz: less than .1% Channel Output typical 1kHz THD: less than .03% Send/ Recieve Connector: One 1/4' stereo phone jack Equivalent Input Noise Direct Out: Via channel send unweighled, 150 ohm source: -128 dBv Output: -10 dBv Output Noise Sub Outputs 1 thru 4 (unweighted/20kHz BM) -90 dBv Sub Output connectors: Four 1/4" phone lacks (two-track, mono, or Maximum output level: +20 dBy monitor outs) Tape Out connectors: Four RCA jacks All faders minimum: -92 dBv 0 VU Nominal output level: +4 dBv unbalanced Master faders nominal -88 dBv Tape Returns 1 thru 4 Maximum Gain Connectors: Four RCA jacks Mic in to two-track out: 70 dB Two-Track Outputs Line in tw-otrack out: 32 dB R & L Balanced connectors: Two 3-pin XLR's Effects return to two-track out: 26 dB Unbalanced connectors: Two RCA jacks Crosstalk 0 VU Nominal output level: +4dBv unbalanced Adjacent channels: -60 dB at 1kHz Mono Output Common Mode Rejection Balanced output connector: 3-pin XLR -75 dB at 1 kHz 0 VU Nominal output level: +4dBv unbalanced Peak Warning Level: 6 GB below clipping Maximum output level: +26 dBv balanced (+14 dBv) Monitor 1 & 2, and Effects 1 thru 4 Sends Phantom Power: +48 voC applied to pins Connectors: Six 1/4" phone jacks 2 and 3 of mic input XLR's Maximum output level: +20 dBv (10k ohm load Channel Equalizer Type: 4 band active Headphone Output 1/4' stereo phone jack Hi band: ±12 dB 0 10 kHz. 100 ohms or higher (stereo) Hi Mid band: ±12 dB 2 kHz Power Amplifier ("P"Powered Models) Mid band: ±12 dB 0 500 Hz 500 WO 4 ohms (250 watts/ch) Low band: ±12 dB 0 100 Hz 340 W 8 ohms (170 watts/ch) Graphic Equalizers (2) In/Out bi-pass switch Total harmonic distortion: .1% (20 Hz to 20k Hz) Type: 9 band at octave intervals Frequency response: 20 Hz to 20k Hz (±-2dB) Max boost/cut: ±12 dB Minimum load impedance: 4 ohms per channel Center frequencies: 63, 125, 250, 500, 1k, 2k, 4k, 8k, Power Supply: Fully regulated & protected 16k Mini-Lamp: 12 Volts (option: G-12V Mini Ligt) Metering High quality dynamic VU meters Power Requirements: 120/240 VAC 50-60 Hz are factory calibrated for +4 dBv Weight: FX&44P 61 Ibs, FX1244P 64 lbs at the unbalanced outputs. Meters FX1644 70 lbs, FX2444 75 may be recalibrated for -10 dBv or Warranty: 1 year +8 dBv at 0 VU