Boss Audio MRGB65 User Manual - Page 3
Be Sure To Observe The Following Guidelines - manual
View all Boss Audio MRGB65 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Thank you for purchasing this MRGB65 6.5" Coax Speakers w/ RGB LED RF Controller Please read through these instructions carefully so you will know how to operate your model properly. After you have finished reading these instructions, keep this document in a safe place for future reference. THIS PACKAGE CONTAINS 2x- MRGB65 / MRGB65S Coax Speakers (Depends on your model) 1x- RF Remote Controller 1x- RGB LED RF Sync Receiver HUB 2x- HUB Wire Extension Kit 2x- Speaker Wire & Mounting Hardware Kit 1x- User Manual / 1x- Warranty Card USER MANUAL QUICK START GUIDE FCC COMPLIANCE STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device. BEFORE YOU START IMPORTANT SAFETY PRECAUTIONS BE SURE TO OBSERVE THE FOLLOWING GUIDELINES: - Do not turn up the volume so high that you can't hear what's around you. - Use caution or temporarily discontinue use in potentially hazardous situations. ■ Do not operate mobile video equipment while driving a motorized vehicle ■ Safe vehicle operation and safety consideration of others should always be your highest priority. ■ Set your volume control at a low setting, then slowly increase the sound until you can hear it comfortably without distortion, or ear discomfort. ■ In the event you should notice smoke, strange noises or odor from this product, or any other abnormal signs, immediately turn off the power and consult your dealer or the nearest authorized BOSS AUDIO Service Center. Using this product in this condition may result in permanent damage to the system. INSTALLATION PRECAUTIONS WARNING - Always consult with a professional installer ■ Do not attempt to install or service this product by yourself. Installation or servicing of this product by persons without professional training and experience in electronic equipment and motorized vehicle accessories may be dangerous and could expose you to the risk of electric shock, injury or other hazards ■ Refer any repairs to a qualified BOSS AUDIO SYSTEMS Service Center ■ The MRGB65 LED RGB SYNC HUB should be wired directly to a normally open switch or relay. ■ When wiring directly to the vehicles battery, be sure to disconnect the batteries negative terminal wire before starting any wiring procedures,if extending the main power wire, it is suggested that an optional fuse and fuse holder (not included) with minimum rating of 10 Amperes be in-line with the positive battery terminal ■ The ground cable length should not exceed 18-inches (See wiring diagram pg 4) ■ The MRGB65 has a weather resistant design, it should not be submerged in or under water under any circumstances ■ Use only the installation parts provided with the MRGB65 2 ENGLISH