Bosch WAT28400UC Instructions for Use - Page 31
Determing the Problem, Problem, Possible causes, Solutions, Temperature, Finish in, Start/Pause
View all Bosch WAT28400UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Determing the Problem Problem Possible cause(s) Solution(s) Washer door cannot be Child lock is activated. opened. Deactivated Child lock (touch and hold Temperature and Finish in for approximately 3 seconds). A power failure occured. If a cycle is interrupted by a power failure, it will resume when the power is restored. Cycle is running, or water level is Wait until the cycle ends. too high and/or too hot. Electric power cord has become loose or unplugged. Make sure the electric cord is securely plugged in. Program selector turned to Off before end of cycle. Emergency door lock released is activated. Turn the program selector to a cycle. ~ Emergency door lock release; Page 30 Door still cannot be opened, even after turning the washer Off and back on again. Child lock is activated Door is locked for safety reasons (high water level, temperature of water hot, or high drum speed (drum is turning). Deactivated Child lock (touch and hold Temperature and Finish in for approximately 3 seconds). Wash cycle time is increased. Your washer utilizes sensors to monitor certain characteristics of the wash load. Increases in wash cycle time could be due to: Solutions are based on the specific reason the wash time has been extended. Excess suds. Ådisplays at end of Use less detergent. cycle. The automatic unbalanced load detection system spins the laundry several times to ensure even distribution. Always load the washer with a mixture of large and small wash items (easier to distribute in the drum). Cycle does not start - Start/Pause button not touched / Touch the Start/Pause button to start the cycle. Start/Pause flashes. selected? Washer door is not closed properly. Check if laundry is caught in the door. Close the door until a click is heard, the cycle should start. Cycle does not start Finish in-Time is displayed. Cycle ending time has been selected and activated. Wash cycle will begin at proper time to complete at the selected finish time. Cycle does not start - Child lock is activated. D symbol flashes. Deactivate Child lock (touch and hold Temperature and Finish in for approximately 3 seconds). Detergent residue remains in the detergent dispenser. Dry detergent may have been damp Clean and dry the detergent dispenser. or lumpy. Excess liquid detergent may have See Adding the correct amount of HE detergent to been added. determine proper detergent usage. Use the dosing cup for liquid deter- Clean and dry the detergent dispenser. gent when dosing powder detergent. Powder detergent may have been damp or lumpy. Water does not appear Start/Pause selected? to be coming into the Water taps not turned on. washer, or detergent is not washed away. Supply hose kinked or pinched (reduce flow). Select Start/Pause. Turn on water taps. Eliminate the cause. Water supply hose strainers clogged. Clean the water inlet strainers. Water pressure too low. Eliminate the cause. Water cannot be seen in the drum. The water level in your high efficiencey front load washer is below the visible part of the drum, this is normal. No action needed. 31