Black & Decker HSVB520J Instruction Manual - Page 7
Warning, Caution
View all Black & Decker HSVB520J manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4. Reassemble the cleaned filter assembly and insert into the dust bowl. 5. To replace the dust bowl, push it back onto the hand vacuum until it clicks firmly into place. WARNING: Never use the appliance without the filters. Optimum dust collection will only be achieved with a clean filter. Fig. F 5 4 Fig. G 18 4 20 19 Cleaning the dust bowl and filter The dust bowl 4 , pre filter 20 and filter 19 can be washed in warm soapy water. 1. Make sure the pre filter 20 , filter 19 and the dust bowl 4 are completely dry before installing. Removing and cleaning the rotary brushes (Fig. H) CAUTION: To reduce the risk of injury from moving parts, disconnect the floor head from the vacuum before cleaning or servicing. • To remove the rotary brush 21 , pinch and lift the plastic tab 22 on the pivoting clip 23 away from the floor head 6 . • Lift the rotary brush 21 out of the floor head. Clear the brushes of any hair or other debris that may have accumulated. • Replace rotary brush, and secure pivoting clip before using vacuum. Fig. H 23 21 6 22 English Replacing the filters The filters should be replaced every 6 to 9 months and whenever worn or damaged. Replacement filters are available from your BLACK+DECKER dealer. Visit www.blackanddecker.com to locate dealers. • Remove the old filters as described in Cleaning the Filters. • Fit the new filters as described in Cleaning the Filters. (cat. no: SVF12) MAINTENANCE Use only mild soap and damp cloth to clean the vac. Never let any liquid get inside the vac; never immerse any part of the vacuum into a liquid. WARNING: Make sure the vacuum is completely dry before using it. IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts. TROUBLESHOOTING If the product does not work, check the following: • The charger was correctly plugged in for recharge. (It feels slightly warm to the touch.) • The charger cord is not damaged and is correctly attached. • The charger is plugged into a working electrical outlet. • The switch is in the "OFF" position when charging. If vacuum performance is poor, check the following: • Clean the filters. (See "Cleaning and emptying the vacuum" section.) • Empty the dust bowl. (See "Cleaning and emptying the vacuum" section.) • Clean the rotary brushes. (See "Removing and cleaning the rotary brushes" section.) • The red LED flashes continuously, plug in the charger and perform a recharge cycle For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK+DECKER help line at 1-800-544-6986. ACCESSORIES Recommended accessories for use with your appliance are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call: WARNING: 1-800-544-6986. The use of any accessory not recommended for use with this appliance could be hazardous. The RBRC® Seal The RBRC® (Rechargeable Battery Recycling Corporation) Seal on the nickel cadmium, nickel metal hydride or lithium- 5