Bissell OptiClean Bagged Canister 42Q8 User Guide - Page 10
Notice, Warning
View all Bissell OptiClean Bagged Canister 42Q8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Maintenance and care Cleaning the Pre-Motor Filter The Pre-motor Filter prevents dust and debris from interfering with the operation of your vacuum. It should be regularly checked for wear or damage and replaced when torn. 1. Turn the power OFF ( ). Unplug the vacuum from electrical outlet. 2. Disconnect hose. 3. Open the dust bag compartment by lifting up on the door latch at the front of the vacuum. Follow the instructions on page 9 to remove and dispose of the dust bag. 4. Remove the filter frame from the filter holder by gently pressing down on the top tab and pulling the filter frame up and away from the filter holder. 5. Remove the filter from the filter frame and clean by hand washing in warm water. A mild detergent can be used if desired. Allow the filter to air dry completely before replacing. 6. Place the filter back into the filter frame and replace back into the filter holder, snapping it back into place. NOTE: The filter frame should be placed so that the protective frame is visible. 7. Following the steps on page 9, replace the dust bag, making sure the entire back is tucked in below the seal gasket. 8. Close dust bag compartment door and press down gently until it locks into place. 9. Reconnect the hose. NOTICE: This product is intended for household use only and not for commercial or industrial use. Vacuuming of dust from products like plaster, concrete or ashes will damage the motor and void the warranty. 4. Pre-Motor Filter Tip: For maximum cleaning performance, check the filters often and clean or replace if necessary. WARNING: Do not operate cleaner with damp or wet filters or without all filters in place. 10 w w w. b i s s e l l . c o m 800.237.7691