Bernina 810 Manual - Page 29
Buttonhole, Re-Inforcing
View all Bernina 810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Buttonhole with Re-Inforcing Cord _ I 3 -°"' 4 , "" Set the buttonhole satin stitch So that the loop of the inserted cord Lay the cord to be Inserted to the left With knob (19) the stitch density can easily be regulated to suit the material. It is recommended to make a trial buttonhole on a remnant of the material to be used. The method of adjusting Is the same as for the satin stitch. (Page 10) will reinforce the buttonhole where the button will pull, place the work to be sewn so that the edge of the material lies in front of the sewing foot and not behind. of the needle, so that when the sowing foot is lowered It will be In the left hand groove of the foot. Sew satin stitch for the first bead. Finish first bead with needle in work end to right of the cord and lift foot. How to sew the buttonhole with reinforcing cord Set machine. Lower needle to the raised foot and make sure that it is In the centre. If not do one stitch by turning the hand wheel towards you, bringing the needle to the centre. Under no circumstances should the zigzag or needle position be changed. Place the work to be sewn under the foot and set the needle exactly at the beginning of the buttonhole. Do not lower the loot yet. Hold cord in left hand and turn work clockwise with right hand until cords are parallel. Lower foot so that first bead now lies under right hand groove of foot. Continue sowing as described. fvlYo.19lo11o11r Y. ull~.ttitLS%