Adaptec 5805 User Guide - Page 36
Before You Begin, Installing the Controller - kit
UPC - 760884154496
View all Adaptec 5805 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Chapter 5: Installing the Controller and Disk Drives ● 36 Before You Begin ● Read Safety Information on page 128. ● Familiarize yourself with your Adaptec RAID controller's physical features and the RAID levels that it supports (see page 16). ● Ensure you have the right quantity of disk drives for the RAID level you want to use for your arrays (see page 32). ● Ensure that you have the proper cables for your controller and disk drives (see page 32). ● If you are installing a low-profile RAID controller into a low-profile computer cabinet, replace the original full-height bracket with the low-profile bracket included in the kit. ! Caution: Handle the controller by its bracket or edges only. Installing the Controller This section describes how to install your Adaptec RAID controller into your computer cabinet. Adaptec RAID controllers come in two basic configurations: standard and zero maintenance cache protection with batteryless backup. Follow one of these sets of instructions: ● To install a standard series Adaptec RAID controller (without zero maintenance cache protection), see the following section. ● To install an Adaptec RAID controller with zero maintenance cache protection, see page 37. Installing a RAID Controller 1 Turn off your computer and disconnect the power cord. Open the cabinet, following the manufacturer's instructions. 2 Select an available PCIe expansion slot that's compatible with your RAID controller and remove the slot cover, as shown at right. (PCIe bus compatibility is marked to the controller figures in About Your RAID Controller on page 15.) ! Caution: Touch a grounded metal object before handling the RAID controller. 3 As shown at right, insert the RAID controller into the expansion slot and press down gently but firmly until it clicks into place. When installed properly, the RAID controller should appear level with the expansion slot. 4 Secure the bracket in the expansion slot, using the retention device (for instance, a screw or lever) supplied with your computer. 5 Connect your computer's disk activity LED cable to the LED connector on the controller (marked on the figures in About Your RAID Controller on page 15). Ensure that the positive lead of the LED cable (usually a red wire or a wire marked with a red stripe) is attached to pin 1.