AEG TR959M6BC User Manual - Page 30

30 www.aeg.com 12.2 Troubleshooting Problem Possible cause Remedy The tumble dryer is not connected Connect it to the mains socket. to the mains supply. Check the fuse in the fuse box (do‐ mestic installation). The tumble dry‐ er does not op‐ erate. The door is open. Close the door. The On/Off button was not pushed. Push the On/Off button. The Start/Pause button was not touched. Touch the Start/Pause button. The appliance is in standby mode. Push the On/Off button. Incorrect program selection. Select a suitable program. 1) The filter is clogged. Clean the filter. 2) Dryness Level option was set to iron dry.3) Change Dryness Level option to a higher level. Unsatisfactory drying result. The load was too large. The airflow slots are clogged. Do not exceed the maximum load size. Clean the airflow slots at the bot‐ tom of the appliance. There is some dirt on the humidity Clean the front surface of the sensor in the drum. drum. The dryness level was not set to the desired level. Adjust the dryness level. 4) The condenser is clogged. Clean the condenser. 2) The loading door does not close The filter is not locked into posi‐ tion. Laundry is trapped between the door and the seal. Put the filter in the correct position. Remove trapped items and close the door. It is not possible to change the program or op‐ tion. After a cycle starts it is not possi‐ ble to change the program or op‐ tion. Turn the tumble dryer off and on. Change the program or option as required. It is not possible The option you tried to select is not Turn the tumble dryer off and on. to select an op‐ available for the selected program. Change the program or option as tion. An acoustic required. signal is emit‐ ted. There is no drum light Defective drum lamp. Contact the service centre to re‐ place the drum lamp.