AEG TR708L0B User Manual - Page 22

22 www.aeg.com Error code Possible cause The mains supply is unstable. EH0 Remedy When the appliance is showing EH0, please wait until main supply is stable than press start. If the ap‐ pliance pause the cycle without any indication then press the cycle start. If the warning will occur check the power cord / socket in‐ tegrity or main supply. If the display shows other error codes, deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre. In case of different problem with the tumble dryer check the table below for possible solutions. 11.2 Troubleshooting Problem Possible cause Remedy The tumble dryer is not connected Connect it to the mains socket. to the mains supply. Check the fuse in the fuse box (do‐ mestic installation). The tumble dry‐ er does not op‐ erate. The door is open. Close the door. The On/Off button was not pushed. Push the On/Off button. The Start/Pause button was not touched. Touch the Start/Pause button. The appliance is in standby mode. Push the On/Off button. Incorrect program selection. Select a suitable program. 1) The filter is clogged. Clean the filter. 2) Dryness Level option was set to Iron Dry.3) Change Dryness Level option to a higher level. Unsatisfactory drying result. The load was too large. The airflow slots are clogged. Do not exceed the maximum load size. Clean the airflow slots at the bot‐ tom of the appliance. There is some dirt on the humidity Clean the front surface of the sensor in the drum. drum. The dryness level was not set to the desired level. Adjust the dryness level. 4) The condenser is clogged. Clean the condenser. 2)