AEG T9DEB969C User Manual - Page 23
Troubleshooting
View all AEG T9DEB969C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
ENGLISH 23 WARNING! Deactivate the appliance before carrying out any check. In case of major problems, the acoustic signals operate, the display shows an alarm code and the Start/Pause button may flash continuously: Possible cause Possible cause Remedy Appliance Motor overloaded. The programme was not comple‐ E5A Too much laundry or entrap in the ted. Remove the laundry from the drum. drum, set the programme and re‐ start the cycle. Internal fail. No communication be‐ The programme was not finished tween electronic elements of the properly or the appliance stoped appliance. too early. Switch the appliance off E97 and on again. If the alarm code appears again, contact the Authorised Service Centre. The mains supply is unstable. When the appliance is showing EH0, please wait until main supply is stable than press start. If the ap‐ EH0 pliance pause the cycle without any indication then press the cycle start. If the warning will occur check the power cord / socket in‐ tegrity or main supply. If the display shows other alarm codes, deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre. In case of different problem with the Tumble dryer check the table below for possible solutions. 12.2 Troubleshooting Problem Possible cause Remedy The tumble dryer is not connected Connect it to the mains socket. to the mains supply. Check the fuse in the fuse box (do‐ mestic installation). The tumble dry‐ er does not op‐ erate. The door is open. Close the door. The On/Off button was not pushed. Push the On/Off button. The Start/Pause button was not touched. Touch the Start/Pause button. The appliance is in standby mode. Push the On/Off button.