AEG L8WEC166R User Manual - Page 32

To have a good drying by

using less energy and in a

shorter time, the appliance

does not let you set a too

low spin speed for the items

to be washed and dried.

2.

Touch button Start/Pause to start the

programme.

In the display the door locked

indicator goes on, the indicator of the

running phase starts flashing.

The display also shows the remaining

programme time.

12.3

Timed Drying

1.

Tap on the button Time Drying

repeatedly to set the desired time

value (see the "Timed drying" table

the "Programmes" chapter). The

drying level indicator goes off and

the indicator

comes on.

Each time you tap on this button the

time value increases by 5 minutes. The

display shows the set new time value.

2.

Touch the Start/Pause to start the

programme.

In the display the door locked

indicator comes on and the indicator of

the running phase starts flashing.

The display also shows the remaining

programme time.

12.4

At the end of the drying

programme

•

The appliance stops automatically.

•

The acoustic signals operate (if they

are active).

•

In the display

comes on.

•

The indicator of button Start/Pause

goes off. The door locked

goes

off

•

Press the button On/Off for some

seconds to deactivate the appliance.

After some minutes from

the end of the

programme, the energy

saving function

deactivates the appliance

automatically.

1.

Remove the laundry from the

appliance.

2.

Make sure that the drum is empty.

After drying phase, clean the

drum, the seal and the inside

of the door with a wet cloth.

13.

FLUFF IN THE FABRICS

During the washing and/or drying phase,

some types of fabric, (sponge, wool,

sweatshirt) could release fluff.

The released fluff could stick to the

fabrics during the next cycle.

This inconvenient increases with

technical fabrics.

To prevent the fluff in your laundry, we

recommend that you:

•

To do not wash dark fabrics after you

washed and dried light coloured

fabrics (hand towel, wool, sweatshirt )

and the contrary.

•

To dry this type of fabrics at open air

when they are washed the first time.

•

To clean the drain filter.

•

After the drying phase, clean the

empty drum, the gasket and the door

with a wet cloth.

To remove the fluff inside the drum,

set a special programme:

•

Empty the drum.

•

Clean the drum, the gasket and the

door with a wet cloth.

•

Set the rinse programme.

•

Simultaneously press the Stains/

Prewash and the Anti-crease buttons

until the display shows

CLE

to activate

the cleaning function.

•

Touch the Start/Pause button to start

the programme.

If the appliance is frequently

used, carry out the

CLE

programme regularly.

www.aeg.com

32

Section	Page
CONTENTS	2
1. SAFETY INFORMATION	3
1.1 Children and vulnerable people safety	3
1.2 General Safety	3
2. SAFETY INSTRUCTIONS	6
2.1 Installation	6
2.2 Electrical Connection	6
2.3 Water Connection	6
2.4 Use	7
2.5 Service	7
2.6 Disposal	7
3. INSTALLATION	7
3.1 Unpacking	7
3.2 Installation on suspended flooring	9
3.3 Positioning and levelling	9
3.4 The inlet hose	9
3.5 Water-stop device	10
3.6 Water drainage	10
4. PRODUCT DESCRIPTION	12
4.1 Appliance overview	12
5. CONTROL PANEL	13
5.1 Control panel description	13
5.2 Display	13
6. DIAL AND BUTTONS	15
6.1 On/Off	15
6.2 Introduction	15
6.3 Temp.	15
6.4 Spin	15
6.5 Stains/Prewash	16
6.6 Delay Start	16
6.7 Quick Wash	16
6.8 Anti-crease	16
6.9 Time Drying	17
6.10 Auto Drying	17
6.11 Mode	17
6.12 Start/Pause	17
7. PROGRAMMES	17
7.1 Programme Chart	17
7.2 Woolmark Apparel Care - Blue	21
7.3 Automatic drying	21
7.4 Timed drying	22
8. BEFORE FIRST USE	23
9. SETTINGS	24
9.1 Child Lock	24
9.2 Acoustic signals	24
9.3 Permanent Extra Rinse	24
10. DAILY USE	24
10.1 Using weight sensors	24
10.2 Before activating the appliance	24
10.3 Activating the appliance and setting a programme	24
10.4 Loading the laundry	25
10.5 Filling the detergent and additives	25
10.6 Check the position of the flap	26
10.7 Starting a programme	27
10.8 Starting a programme with the delay start	27
Cancelling the delay start after the countdown has started	27
Changing the delay start after the countdown has started	27
10.9 The ProSense load detection	27
10.10 Programme phase indicators	27
10.11 Interrupting a programme and changing the options	28
10.12 Cancelling a running programme	28
10.13 Opening the door - Adding garments	28
10.14 End of the programme	28
10.15 Draining water out after end of cycle	29
10.16 Stand-by option	29
11. DAILY USE - WASHING & DRYING	29
11.1 Complete wash&dry programmes	30
Automatic Non-Stop programme	30
Non-automatic wash&dry programmes	30
11.2 Washing and Drying - Automatic levels	30
11.3 Washing and Timed Drying	30
11.4 At the end of the drying programme	31
12. DAILY USE - DRYING ONLY	31
12.1 Preparation to drying	31
12.2 Drying - Automatic levels	31
12.3 Timed Drying	32
12.4 At the end of the drying programme	32
13. FLUFF IN THE FABRICS	32
14. HINTS AND TIPS	33
14.1 The laundry load	33
14.2 Stubborn stains	33
14.3 Detergents and other treatments	33
14.4 Ecological hints	33
14.5 Water hardness	34
14.6 Prepare the drying cycle	34
14.7 Items not suitable for drying	34
14.8 Garment labels	34
14.9 Drying cycle duration	34
14.10 Additional drying	34
14.11 General Tips	34
15. CARE AND CLEANING	34
15.1 External cleaning	34
15.2 Descaling	35
15.3 Maintenance wash	35
15.4 Door seal	35
15.5 Cleaning the drum	35
15.6 Cleaning the detergent dispenser	35
15.7 Cleaning the drain pump	36
15.8 Cleaning the inlet hose and the valve filter	38
15.9 Emergency drain	39
15.10 Frost precautions	39
16. TROUBLESHOOTING	39
16.1 Introduction	39
16.2 Possible failures	40
16.3 Emergency door opening	42
17. CONSUMPTION VALUES	43
18. TECHNICAL DATA	44
19. ACCESSORIES	45
19.1 Available in www.aeg.com/shop or from authorised dealer	45
19.2 Fixing plate kit	45

AEG L8WEC166R User Manual - Page 32

Fluff In The Fabrics

Page 32 highlights