AEG L7FEE845R User Manual - Page 23
The ProSense load
![]() |
View all AEG L7FEE845R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
In case a selection is not possible, no indicator comes on and an acoustic signal sounds. 10.6 Starting a programme Touch the Start/Pause button to start the programme. The related indicator stops flashing and stays on. In the display, the indicator of the operating phase starts flashing and the maximum load indicator goes off. The programme starts, the door is locked. The display shows the indicator . The drain pump can operate shortly before the appliance fills water. 10.7 Starting a programme with the delay start 1. Touch the Delay Start button repeatedly until the display shows the desired delay time. The indicator goes on. 2. Touch the Start/Pause button. The appliance starts the countdown of the delay start. When the countdown is completed, the programme starts. The PROSENSE estimation starts at the end of the countdown. Cancelling the delay start after the countdown has started To cancel the delay start: 1. Touch the Start/Pause button to pause the appliance. The related indicator flashes. 2. Touch the Delay Start button repeatedly until the display shows . 3. Touch the Start/Pause button again to start the programme immediately. ENGLISH 23 Changing the delay start after the countdown has started To change the delay start: 1. Touch the Start/Pause button to pause the appliance. The related indicator flashes. 2. Touch the Delay Start button repeatedly until the display shows the desired delay time. 3. Touch the Start/Pause button again to start the new countdown. 10.8 The ProSense load detection The programme duration in the display is referred to a medium/high load. After touching the Start/Pause button, the maximum declared load indicator goes off, the indicator flashes, the ProSense starts the laundry load detection: 1. The appliance detects the load in the first 30 seconds: the indicator and the time dots flash, the drum rotates shortly. 2. At the end of the load detection, the indicator goes off and the time dots stop flashing. The programme duration will be adjusted accordingly and could increase or decrease. After further 30 seconds, the water filling starts. At the end of the load detection, in case of drum overload, the indicator is flashing in the display: In this case, for 30 seconds, it is possible to pause the appliance and remove the exceeding garments. Once removed the exceeding garments, touch the Start/Pause button to start the programme again. The ProSense phase can be repeated up to three times (see point 1). Important! If the laundry amount will not be reduced, the washing programme starts anyway, despite the overload. In
![](/manual_guide/products/aeg-l7fee845r-user-manual-4257a2b/23.png)