2012 Yamaha Motorsports V Star 250 Owners Manual - Page 62
2012 Yamaha Motorsports V Star 250 Manual
Page 62 highlights
PERIODIC MAINTENANCE AND ADJUSTMENT EAU23016 EAU23095 Tightening torques: Drive chain puller locknut: 16 Nm (1.6 m·kgf, 12 ft·lbf) Axle nut: 105 Nm (10.5 m·kgf, 76 ft·lbf) Cleaning and lubricating the drive chain The drive chain must be cleaned and lubricated at the intervals specified in the periodic maintenance and lubrication chart, otherwise it will quickly wear out, especially when riding in dusty or wet areas. Service the drive chain as follows. ECA10583 Checking and lubricating the cables The operation of all control cables and the condition of the cables should be checked before each ride, and the cables and cable ends should be lubricated if necessary. If a cable is damaged or does not move smoothly, have a Yamaha dealer check or replace it. WARNING! Damage to the outer housing of cables may result in internal rusting and cause interference with cable movement. Replace damaged cables as soon as possible to prevent unsafe conditions. [EWA10711] 6. Adjust the brake pedal free play. (See page 7-21.) EWA10660 WARNING After adjusting the brake pedal free play, check the operation of the brake light. 7. Make sure that the drive chain pullers are in the same position, the drive chain slack is correct, and the drive chain moves smoothly. 7 NOTICE The drive chain must be lubricated after washing the motorcycle, riding in the rain or riding in wet areas. 1. Remove all dirt and mud from the drive chain with a brush or cloth. TIP For a thorough cleaning, have a Yamaha dealer remove the drive chain and soak it in solvent. 2. Spray Yamaha Chain and Cable Lube or a high-quality spray-type drive chain lubricant on the entire chain, making sure that all side plates and rollers have been sufficiently oiled. 7-26 Recommended lubricant: Yamaha Chain and Cable Lube or engine oil