2012 Yamaha Motorsports FX Nytro M-TX 162 Owners Manual - Page 22
2012 Yamaha Motorsports FX Nytro M-TX 162 Manual
Page 22 highlights
Control functions See "Fuel meter and grip/thumb warmer level indicator" on page 13 for detailed information. ESU10696 Auxiliary DC jack (FX10M53S/FX10M62S) The auxiliary DC jack is located in the front panel and can be used for accessories. TIP 1. Headlight beam switch "LIGHTS" 2. High beam "HI" 3. Low beam "LO" ESU10676 The auxiliary DC jack can only be used if the engine is running. To use the auxiliary DC jack 1. 2. Start the engine. Open the auxiliary DC jack cap, and then insert the accessory power plug into the jack. Grip/thumb warmer adjusting switch The grip/thumb warmer adjusting switch controls the electrically heated handlebar grips and throttle lever. 1 1. Auxiliary DC jack cap 2. Auxiliary DC jack 1. Grip/thumb warmer adjusting switch 3. To raise the temperature To raise the grip warmer temperature, press the " " side of the switch. To raise the thumb warmer temperature, press the " " side of the switch. After using the auxiliary DC jack, be sure to remove the accessory power plug from the jack and to close the auxiliary DC jack cap. ECS00122 NOTICE G To lower the temperature Continue to press the switch until the temperature level returns to the minimum level, and then raise the temperature to the desired level. To avoid circuit overload and a possible fuse blowing, do not use accessories requiring more than the maximum rated capacity for the auxiliary DC jack. (See page 80 for the specified fuse amperage.) 16