2010 Yamaha Motorsports RS Viking Professional Owners Manual - Page 59

2010 Yamaha Motorsports RS Viking Professional Manual

Get 2010 Yamaha Motorsports RS Viking Professional PDF manuals and user guides View all 2010 Yamaha Motorsports RS Viking Professional manuals

Page 59 highlights

Periodic maintenance and adjustment 1. Secondary sliding sheave 2. Secondary fixed sheave 2 1 4. Pull the V-belt up over the secondary fixed sheave. 1. Edge of the secondary sheave assembly 2. Standard V-belt position 1. V-belt 5. 6. Remove the V-belt from the secondary sheave assembly and primary sheave assembly. Temporarily install the new V-belt on the secondary sheave assembly only, and then measure the V-belt position. Do not force the V-belt between the sheaves; the secondary sliding and fixed sheaves must touch each other. Standard V-belt position: From 1.5 mm (0.06 in) above the edge of the secondary sheave assembly to 0.5 mm (0.02 in) below the edge 7. If the V-belt position is incorrect, adjust it by removing or adding a spacer on each V-belt position adjusting bolt. 53

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
Periodic maintenance and adjustment
53
4.
Pull the V-belt up over the secondary
fixed sheave.
5.
Remove the V-belt from the secondary
sheave assembly and primary sheave
assembly.
6.
Temporarily install the new V-belt on the
secondary sheave assembly only, and
then measure the V-belt position. Do not
force the V-belt between the sheaves; the
secondary sliding and fixed sheaves
must touch each other.
7.
If the V-belt position is incorrect, adjust it
by removing or adding a spacer on each
V-belt position adjusting bolt.
1.
Secondary sliding sheave
2.
Secondary fixed sheave
1. V-belt
1.
Edge of the secondary sheave assembly
2.
Standard V-belt position
Standard V-belt position:
From 1.5 mm (0.06 in) above the
edge of the secondary sheave as-
sembly to 0.5 mm (0.02 in) below the
edge
2
1