2010 Yamaha Motorsports RS Venture GT Owners Manual - Page 78
2010 Yamaha Motorsports RS Venture GT Manual
Page 78 highlights
Periodic maintenance and adjustment (b) 1 1 1. Weatherstrip (a) 1. Headlight beam adjusting screw 11. Install the headlight unit bolts and windshield stay bolts, and then tighten them to their specified torques. Tightening torques: Headlight unit bolt: 3 Nm (0.3 m·kgf, 2.2 ft·lbf) Windshield stay bolt: 14 Nm (1.4 m·kgf, 10 ft·lbf) 12. Install the top cover and the shroud. ESU12270 3. Install the top cover. ESU12290 Fittings and fasteners Check the tightness of the fittings and fasteners. Tighten in proper sequence and torque if necessary. ESU12303 Battery This model is equipped with a VRLA (Valve Regulated Lead Acid) battery. There is no need to check the electrolyte or to add distilled water. However, the battery lead connections need to be checked and, if necessary, tightened. EWS00540 Adjusting the headlight beams 1. 2. Remove the top cover. (See page 45 for removal procedures.) Use a Phillips screwdriver to turn the headlight beam adjusting screw and adjust the headlight beams. To lower the headlight beams, turn the headlight beam adjusting screw in direction (a). To raise the headlight beams, turn the headlight beam adjusting screw in direction (b). WARNING Battery electrolyte is poisonous and dangerous. It contains sulfuric acid and can cause severe burns. Avoid contact with skin, eyes, or clothing. ANTIDOTE: G EXTERNAL: Flush with water. G INTERNAL: Drink large quantities of water or milk. Follow with milk of magnesia, beaten egg, or vegetable oil. Call physician immediately. G EYES: Flush with water for 15 minutes and get prompt medical attention. 72