2009 Yamaha Motorsports FX Nytro MTX Owners Manual - Page 21

Control functions ESU10691 ESU10560 Auxiliary DC jack (FX10MTR) The auxiliary DC jack is located in the front panel and can be used for accessories. Brake lever The snowmobile is stopped by braking the entire drive system. Squeeze the brake lever towards the handlebar grip to stop the snowmobile. TIP The auxiliary DC jack cannot be used if the engine is not running. To use the auxiliary DC jack 1. Start the engine. 2. Open the auxiliary DC jack cap, and then insert the accessory power plug into the jack. 1. Brake lever TIP When the brake lever is operated, the brake light will illuminate. ECS00060 NOTICE 1. Auxiliary DC jack cap 2. Auxiliary DC jack 3. After using the auxiliary DC jack, be sure to remove the accessory power plug from the jack and to close the auxiliary DC jack cap. Make sure that the brake lever end does not project out over the handlebar end. This will help prevent brake lever damage when the snowmobile is placed on its side for service. The brake lever is equipped with a position adjuster. To adjust the brake lever position: 1. Loosen the locknut. 2. While lightly pushing the brake lever in direction (a), finger tighten the adjusting bolt to set the brake lever to the desired position. ECS00120 NOTICE G G Do not use accessories requiring more than the maximum rated capacity for the auxiliary DC jack. This may overload the circuit and cause the fuse to blow. (See page 69 for the specified amperage.) Do not use an automotive cigarette lighter or other accessory with a plug that gets hot because the jack can be damaged. Maximum rated capacity: DC 12 V, 2.5 A (30 W) 15