2008 Yamaha Motorsports Vino 125 Owners Manual - Page 46
2008 Yamaha Motorsports Vino 125 Manual
Page 46 highlights
PERIODIC MAINTENANCE AND MINOR REPAIR 1 2 1 2 3 ZAUM00** 5. Clean the oil strainer with solvent, and then check it for damage and replace it if necessary. 3 4 1 1. Engine oil level check window 2. Maximum level mark 3. Minimum level mark ZAUM00** 3 2 1 4 5 6 7 8 9 1. Engine oil filler cap 1 ZAUM00** 4. If the engine oil is below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level. To change the engine oil and clean the oil strainer 1. Start the engine, warm it up for several minutes, and then turn it off. 2. Place an oil pan under the engine to collect the used oil. 3. Remove panel A. (See page 6-8.) 4. Remove the engine oil filler cap and drain bolts to drain the oil from the crankcase. 1. 2. 3. 4. Engine oil drain bolt B O-ring Compression spring Strainer 1 ZAUM00** 1. Engine oil drain bolt A ECA10410 cC When removing the engine oil drain bolt, the O-ring, spring, and oil strainer will fall out. Take care not to lose these parts. 6-10 6. Check the O-ring for damage and replace it if necessary. 7. Install the oil strainer, spring, O-ring and engine oil drain bolts, and then tighten the drain bolts to the specified torque.