2008 Yamaha Motorsports Roadliner S Owners Manual - Page 23
2008 Yamaha Motorsports Roadliner S Manual
Page 23 highlights
INSTRUMENT AND CONTROL FUNCTIONS 1. Push the "SELECT" switch to change the display to the clock mode. 2. Push the "SELECT" and reset switches together for at least two seconds. 3. When the hour digits start flashing, push the reset switch to set the hours. 4. Push the "SELECT" switch, and the minute digits will start flashing. 5. Push the reset switch to set the minutes. 6. Push the "SELECT" switch and then release it to start the clock. Self-diagnosis device This model is equipped with a self-diagnosis device for various electrical circuits. If any of those circuits are defective, the engine trouble warning light will come on, and then the odometer/tripmeter/clock display will indicate a two-digit error code. If the odometer/tripmeter/clock display indicates any error codes, note the code number, and then have a Yamaha dealer check the vehicle. ECA11590 CAUTION: If the display indicates an error code, the vehicle should be checked as soon as possible in order to avoid engine damage. Brightness control mode the speedometer, tachometer, and the fuel gauge needles (item number "3") Select the brightness control mode as follows. 1. Turn the key to "OFF". 2. Push and hold the "SELECT" switch. 3. Turn the key to "ON", and then release the "SELECT" switch after five seconds. Item number "1" is displayed. G 3 1. 2. 3. 4. 5. Multi-function meter unit panel LCD Speedometer needle Tachometer needle Fuel gauge needle The brightness can be adjusted for the following: G the multi-function meter unit panel (item number "1") G the LCD (item number "2") 3-6 1. Multi-function meter unit panel 2. Item number 3. Brightness level 4. Adjust the multi-function meter unit panel brightness level by pushing the reset switch.