2013 Volvo C30 Owner's Manual - Page 112
2013 Volvo C30 Manual
Page 112 highlights
04 Interior Front seats NOTE Both front seats are equipped with head restraints that can be adjusted vertically to suit the height of the passenger. The upper edge of the head restraint should be at least on a level with the upper-most point of the seat occupant's ear (see the section "Adjusting the front seat head restraints" on page 111). 04 Programming the seat memory, driver's seat only* 3. With the "M" button depressed, press memory button 1 to store the seat's current position. To move the seat to the position that it was in when memory button 1 was programmed, press and hold down button 1 until the seat stops moving. As a safety precaution, the seat will stop automatically if the button is released before the seat has reached the preset position. NOTE The power seats have an overload protector that activates if a seat is blocked by any object. If this occurs, switch off the ignition (key in position 0) and wait for approximately 20 seconds before operating the seat again. Central locking system remote key and driver's seat memory The remote key transmitter can also be equipped with an optional function that controls the electrically operated driver's seat in the following way: 1. Adjust the seat to the desired position. 2. When you leave the car, lock it using the remote key. 3. The next time the driver's door is unlocked with the same remote key and that door is opened within 2 minutes, the driver's seat and side door mirrors will automatically move to the position that they were in when the doors were most recently locked with the same remote key. G020200 Power seat memory buttons Emergency stop If the seat inadvertently begins to move, press any of the buttons to stop the seat. Three different seating positions can be stored in the seat's memory. The memory buttons are located on the outboard side of the driver's seat (see the illustration above). The following example explains how memory button 1 can be programmed. Buttons 2 and 3 can be programmed in the same way. To program (store) a seat position in memory button 1: 1. Adjust the seat to the desired position. 2. Press and hold down the "M" (Memory) button. 110 * Option/accessory, for more information, see Introduction.