2006 Volvo S60 Owner's Manual - Page 53
2006 Volvo S60 Manual
Page 53 highlights
Using the remote control Button 1: Press to extend the key. This button must also be pressed when the key is folded back into the slot in the side of the remote control unit. Button 2(Lock): Press once to lock all doors, and the trunk. Button 3(Approach light): Press this button when approaching the car at night to light up the interior courtesy light, parking lights, license plate lights and the lights in the sideview mirrors. Button 4(Panic): See page 78 for more information on this function. Button 5(Open trunk): Press this button twice within 3 seconds to pop open the trunk (without unlocking the other doors). Button 6(Unlock): Press this button once to unlock the driver's door only. Wait for at least 1 second and press the button again (within 10 seconds) to unlock all doors, and the trunk. NOTE: If an airbag deploys, your vehicle's SRS control module will attempt to automatically unlock all doors. The keys may also be used to lock and unlock the doors, and to activate and deactivate the alarm system. To avoid leaving your keys in the car, make a habit of always locking the car with the remote control. Automatic re-locking If the doors are unlocked, the locks will automatically re-engage (re-lock) and the alarm will rearm after 2 minutes unless a door or the trunk has been opened. pg. 74 Locks and alarm FCC ID:LQNP2T-APU This device complies with part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Canadian 2306104388 Model 504 2927 by Donnelly Operation is subject to the following conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Canadian 2306104388A Model 509 977 by Connaught Electronics Operation is subject to the following conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.