2014 Polaris 800 Switchback Assault Owners Manual - Page 61
2014 Polaris 800 Switchback Assault Manual
Page 61 highlights
OPERATION Starting the Engine NOTICE: Engaging the starter when the engine is running WILL result in serious engine damage, especially if the transmission is in reverse. Never engage the starter when the engine is running. 1. Turn the key to the ON position. 2. Pull the engine stop switch up to the RUN position. 3. If equipped with electric start, turn the key to START to crank the engine. Release the key to the ON position when the engine starts. 4. If not equipped with electric start, grasp the starter handle and pull slowly until the recoil engages; then pull abruptly to crank the engine. TIP: Don't pull the starter rope to the fully extended position and don't allow it to snap back into the housing. Damage may result. 5. If the engine does not start after several attempts, slightly depress the throttle (no more than 1/4" open) while cranking the engine. When the engine starts, immediately release the throttle. CAUTION! To avoid injury and/or engine damage, do not operate the electric starter or pull-rope starter while the engine is running. NOTICE: Operating the vehicle immediately after cold starting could cause engine damage. Allow the engine to warm up for several minutes before operating the vehicle. If cold drive-away is attempted, the engine RPM may stumble slightly to protect the engine. Restarting an Engine If the rider stops the engine by pushing the engine stop switch down, restart the engine using the normal starting procedure. If the engine fails to start using the normal procedure: 1. Push the engine stop switch down to the OFF position. 2. Turn the key to the OFF position. 3. With both switches OFF, squeeze and hold the throttle in the wide open position. 4. Crank the engine several times to clear the engine. 5. Release the throttle. 6. Restart the engine using the normal starting procedure. 59