2013 Polaris Vegas 8-Ball Owners Manual - Page 72
2013 Polaris Vegas 8-Ball Manual
Page 72 highlights
Maintenance Headlight Aim Inspection The top edge of the high beam must be 3 inches (7.6 cm) below the height of the headlight housing parting line and centered straight ahead at 25 feet (7.6 m). 1. Verify that tire pressure is at specification. See page 63. 2. Verify that rear suspension ride height (preload) is at specification. Include rider, passenger (if applicable) and cargo when setting preload. See page 53. 3. Position the motorcycle on a level surface with the headlight 25 feet (7.6 m) from a wall. With the operator and passenger (if applicable) on board, bring the motorcycle to the fully upright position. 4. Move the ignition switch to the ON position and switch the headlamp to high beam. Observe the headlight aim on the wall. 5. Make any necessary adjustments to headlight aim. High Beam 25 ft. (7.6 m) 3 in. (7.6 cm) Height of headlamp housing parting line Low Beam Lamp Position Lamp High Beam Lamp Headlight Aim Adjustment 1. To adjust the headlamp vertically, hold the headlamp firmly while loosening the adjustment bolt. Adjust the headlamp and hold it firmly in position while tightening the bolt. Torque: 35 ft-lbs (47.5 Nm) 2. To adjust the headlamp horizontally, loosen the horizontal adjustment nut. Adjust the headlamp and hold it firmly in position while tightening the nut. Torque: 28 ft-lbs (38 Nm) Vertical Adjustment Bolt 3. Verify proper headlight aim. Readjust if necessary. Horizontal Adjustment Nut 70