2007 Polaris 120 Owners Manual - Page 30

ADULT SECTION Pre-Ride Check n Check the throttle safety switch Test the throttle safety switch system on a daily basis before the vehicle is used. With the engine idling, hold the throttle lever pin stationary by exerting pressure on the pivot pin in the direction shown in the illustration. Apply a slight amount of throttle opening. A properly functioning switch must shut down the engine. The throttle safety switch is designed to stop the engine whenever all pressure is removed from the throttle lever and the throttle cable or valve does not return to the normal closed position. If excessive play develops in the throttle cable, the safety switch may be activated and will prevent the engine from starting. If the engine doesn't start and throttle safety switch malfunction is suspected, return the machine to an authorized Polaris .03 in. (.8 mm) dealer for service. If an adult must start the engine in an emergency situation, the throttle safety switch and engine stop switch may be disconnected from the wire harness. In this situation, the ignition key switch must be used to shut off the engine. Be sure to reconnect the safety switches and have the snowmobile serviced before operating the vehicle again. WARNING Do not continue to operate the vehicle with the throttle safety switch disconnected as serious injury or death could result. See your authorized Polaris dealer for service before operating. 27