2007 Lincoln Navigator Quick Reference Guide 1st Printing - Page 2

when the wiper control

is set in the intermittent

position, the speed-

sensitive feature

automatically adjusts

the wipers as the

vehicle’s speed changes.

Push in the end of the

stalk briefly for

a single

wipe (no wash).

Push in

and hold to activate the

washer. The inner ring

on the right operates

the rear window wiper.

Rotate the control to 1

(slow interval), 2 (fast

interval), or washer

position. For extended

wiper blade quality,

occasional cleaning

of the wiper blades

is required.

5.

HOOD RELEASE:

Pull the hood release

handle. Next, release

the auxiliary latch with

the handle located

under the front of the

hood, just above the

passenger-side head-

lamp. Slide the yellow

handle away from the

center of the vehicle to

release the auxiliary

latch. Lift the hood

until the lift cylinders

hold it open.

6.

SPEED CONTROL:

To operate, the speed

control must be ON

and the vehicle speed

must be greater than

30 mph (48 km/h). To

set a speed, press SET

+. Once the system is

engaged, an icon will

illuminate. To set a

higher speed, press

SET + again. To set

a lower speed, press

SET –. Pressing

RESUME will return to

a previously set speed.

To disengage the

speed control without

erasing the previously

programmed set speed

depress the brake

pedal. To turn the

speed control off,

press the OFF button

or turn off the ignition.

7.

ABS WARNING

LAMP

:

Illuminates

briefly when the ignition

is turned to the ON

position. In an emer-

gency,

apply continuous

force on the brake to

prevent wheel lockup

1

1

2

3

4

5

6

7

8

9

10

12

11

you or away from you.

Adjust the pedals only

when the vehicle is

stopped and the

gearshift lever is in the

P (Park) position.

3.

PARKING BRAKE

WITH AUTO-RELEASE

(IF EQUIPPED):

To release

the parking

brake using the auto-

matic release feature,

turn the ignition to the

ON position and then

press the brake pedal.

Move the gearshift out

of the P (Park) position

with the brake pedal

depressed. If the parking

brake fails to release

after this

procedure is

completed,

pull the

manual parking brake

release lever to

release the brake.

To set the parking

brake, press the

parking brake pedal

down until the pedal

stops. The BRAKE

warning lamp in the

instrument cluster will

illuminate (when the

ignition is turned ON)

until the parking brake

is released.

4.

TURN SIGNAL AND

WIPER / WASHER

CONTROL:

For front

wiper operation, rotate

the end of the control

to the desired interval,

low or high-speed

position.

When in the

intermittent

position,

rotate the control up for

fast,

or down for slow

wiping

intervals. Also,

when braking on

slippery surfaces –

do not pump your

brakes. Any pulsation

or noise you may feel or

hear is normal.

8.

SERVICE ENGINE

SOON LAMP

:

Illuminates briefly

when the ignition is

turned to the ON

position to ensure the

system is functional.

If the light comes on

after the engine is

started, please consult

your Owner’s Guide.

To help prevent

activation, always

secure your fuel cap by

turning it clockwise 1/4

of a turn until at least a

few clicks are heard.

If the fuel cap

is not

properly secured,

the

warning "CHECK FUEL

CAP" will be displayed

on the message center.

The warning will be

reset once the cap is

properly tightened and

your vehicle is driven a

short distance.

9.

GEARSHIFT / OVER-

DRIVE CONTROL:

D (drive) with overdrive

is the normal position

for the best fuel

economy. Only deactivate

overdrive when: driving

with a heavy load,

towing a trailer up or

down steep hills, or

when additional engine

braking is desired.

To deactivate, press the

transmission control

switch on the side of

the gearshift lever. The

O/D OFF lamp will be

illuminated and 5th

and 6th gear overdrive

will be disabled.

To return to overdrive,

press the transmission

control switch. The O/D

OFF lamp will not be

illuminated. Overdrive

is automatically

returned each time the

key is

turned off. First

through

fourth gears

can also be manually

selected by moving the

gearshift lever into

positions 1, 2, 3, 4.

10.

CONTROL TRAC

FOUR-WHEEL DRIVE

(4X4) OPERATION (IF

EQUIPPED):

4X2 (2WD)

delivers

power to the rear

wheels only. This

is appropriate for

normal on-road driving

on dry pavement.

4X4 AUTO

provides

electronic control

four-wheel drive with

power delivered to all

four wheels, as

required, for increased

traction. The message

center will display

“ 4X4 AUTO” when this

position is selected.

4X4

provides electroni-

cally locked four-wheel

drive power to all four

wheels. The message

center will display

“ 4X4” when

this

position is selected.

To shift between

modes, press any

button (4X2, 4X4

AUTO or 4X4) at any

forward speed up to 55

mph (88km/h). The

message center may

display “ 4X4 SHIFT

IN PROGRESS” during

the system shift. The

message center will

then display “ 4X4

AUTO” if 4X4 AUTO is

selected or “ 4X4” if

4X4 is selected.

NOTE:

Some noise may be

heard as the system

shifts or engages.

11.

HAZARD FLASHER

CONTROL:

Press to

activate all hazard

flashers simultaneously

in an emergency to

warn traffic of vehicle

breakdown, approaching

danger, etc. Press the

control again to turn

the flashers off. The

hazard flashers can be

operated when the

ignition is off.

12.

REAR WINDOW

DEFROSTER:

Press

to activate rear window

defrost. The rear defrost

indicator will illuminate.

When in operation, the

rear window defroster

also defrosts the side

view mirrors. The rear

window defroster will

automatically turn

off after approximately

10 minutes of operation.

Press the control again

to re-engage if needed.

POWER FOLD

MIRRORS:

Rotate the

4-way adjustment

switch, located on the

driver’s door, to the

center position. Press

the switch toward you to

fold in the the mirrors.

Press again to fold them

back to the original

position. Fold the side

mirrors in carefully when

driving through a narrow

space, like an automatic

car wash. If you fold in a

mirror manually, the

power fold mirrors will

need to be reset. To

reset, move the 4-way

adjustment switch to the

center position. Press

the switch toward you to

fold the mirrors in, and

wait for approximately

8 seconds. You should

hear a clicking sound

indicating that the

mirrors have been reset.

If you do not hear the

clicking sound, press

the switch to fold

the mirrors back

out, and repeat the

reset procedure.

COCKPIT

1.

HEADLAMP AND

PANEL DIMMER

CONTROL:

Rotate

clockwise one position

from off to turn on the

parking lamps. Rotate

two positions from off

to also turn on the

headlamps. Rotate

counterclockwise to

activate the autolamp,

which provides light-

sensitive automatic

on-off control of the

exterior lights and

keeps them on for a

short period of time

after the ignition is

turned OFF. When the

control is in any

position except high

beams or off, pull the

control toward you to

activate the foglamps.

Use the panel dimmer

control, located to the

right of the headlamp

control, to adjust the

brightness of the

instrument panel

during headlamp and

parklamp operation.

Rotate to the full up

position to turn on

interior lamps.

2.

POWER ADJUSTABLE

PEDALS:

Press and hold

the rocker control to

adjust the accelerator

and brake pedal toward

AUDIO

1

5

7

8

9

2

3

4

5

6

THX II –

Your vehicle may be equipped with the

THX II certified premium audio system. This

system creates optimal acoustic quality for all

seating positions and road conditions. The system

offers an advanced speaker system, amplifiers,

subwoofer,and equalization.

1

LOAD –

Press to load a CD. Press Load and a

memory preset to load a specific slot. Press and

hold to auto load up to six CDs.

2

ON/OFF/VOLUME –

Press to turn ON/OFF. Turn

to increase/decrease volume. If the volume is set

above a certain level and the ignition is turned

off, the volume will come back on at a “ nominal”

listening level when the ignition switch is turned

back on.

SATELLITE RADIO CONTROLS

(IF EQUIPPED)

:

3

AUX –

Press repeatedly to cycle through SAT1,

SAT2, SAT3 (satellite radio mode if equipped) or

LINE IN (auxiliary audio mode). Once Satellite

Radio mode is activated you may use the following

functions: Press MENU until CATEGORY MODE

appears in the display. Press

/

to select from

various categories of music (country, rock, etc.)

and press

SEEK

or press and hold TEXT/SCAN

to search for channels playing music. Press

SEEK

to access the previous /next channels.

Press and release TEXT/SCAN to display the

current song title. Press again to scroll through

current song title, artist, channel category and

the SIRIUS long channel name. Press and hold

for a brief sampling of the next channels. Press

again to stop.

4

SHUFFLE –

Press to play all tracks on the

current CD/MP3 disc in random order.

5

SEEK –

Press to access the previous/next

strong station or CD track.

6

TEXT/SCAN –

In radio mode, when listening to

a RBDS-equipped station, press and release to

view the text information of the radio station,

if available. Press and hold for a brief sampling

of radio stations. In CD/MP3 mode, press and

release to view the track title, artist name, disc

title or file name, if available. Press and hold for

a brief sampling of all tracks on the current disc.

7

MUTE –

Press to mute the playing media.

Press again to return to the playing media.

8

MENU –

Press repeatedly to toggle through:

AUTOSET –

Allows you to set the strongest local

radio stations without losing your original stored

stations in AM/FM1/FM2. Use to turn on/off.

When the six strongest stations are filled, the

station stored in preset 1 will begin playing. If

there are less than six strong stations, the system

will store the last one in the remaining presets.

OCCUPANCY MODE –

Use to select and optimize

sound for ALL SEATS, DRIVERS SEAT or

REAR SEATS.

SPEED SENSITIVE VOLUME –

Radio volume

automatically

changes slightly with vehicle speed

to compensate

for road and wind noise.

Recommended level is 1-3. SPEEDVOL OFF turns

the feature off and level 7 is the maximum

setting. When the vehicle is stopped, volume is

significantly lowered.

COMPRESSION –

Brings soft and loud CD

passages together for a more consistent listening

level when in CD mode. Press MENU until

compression status is displayed. Press

/

to

turn the feature on/off.

RBDS (RADIO BROADCAST DATA SYSTEM) –

In FM mode, this feature allows you to search

for certain categories of music or announcements.

For more information, refer to your Owner’s Guide.

9

TUNE –

Turn to go up/down the frequency band

in individual increments, or to advance to the

next/previous MP3 folder.

AUXILIARY INPUT JACK (AIJ) –

Your vehicle is

equipped with an Auxiliary Input Jack (AIJ) located

inside the console bin. This allows you to plug

and play auxiliary audio devices. Press AUX

repeatedly on your audio system to access.

When LINE IN appears in the display, plug in

your auxiliary audio device. For more detailed

information, please refer to your Owner’s Guide.

2007 Lincoln Navigator Quick Reference Guide 1st Printing - Page 2

2007 Lincoln Navigator Manual

Page 2 highlights