2006 Lincoln LS Owner's Manual - Page 178
2006 Lincoln LS Manual
Page 178 highlights
Seating and Safety Restraints are not properly restrained or are otherwise out of position at the time of airbag deployment. Thus, it is extremely important that occupants be properly restrained as far away from the airbag module as possible while maintaining vehicle control. Several air bag system components get hot after inflation. Do not touch them after inflation. If the air bag has deployed, the air bag will not function again and must be replaced immediately. If the air bag is not replaced, the unrepaired area will increase the risk of injury in a collision. The SRS consists of: • driver and passenger airbag modules (which include the inflators and airbags) • side airbags. Refer to Side airbag system later in this chapter • safety belt pretensioners • one or more impact and safing sensors • a readiness light and tone • and the electrical wiring which connects the components The diagnostic module monitors its own internal circuits and the supplemental airbag electrical system wiring (including the impact sensors), the system wiring, the airbag system readiness light, the airbag back up power, the airbag ignitors and safety belt pretensioners. Determining if the system is operational The SRS uses a readiness light in the instrument cluster or a tone to indicate the condition of the system. Refer to the Airbag readiness section in the Instrument cluster chapter. Routine maintenance of the airbag is not required. Any difficulty with the system is indicated by one or more of the following: • The readiness light will either flash or stay lit • The readiness light will not illuminate immediately after ignition is turned to the RUN position 178 2006 Lincoln LS (dew) Owners Guide (post-2002-fmt) USA (fus)