2007 BMW 6 Series Owner's Manual - Page 215

Have work on the xenon lighting system performed only by your BMW center or a workshop that works according to BMW repair procedures with correspondingly trained personnel. Due to the high voltage involved, there is a danger to life and limb when work is carried out improperly.< Front turn signals, side marker lamps Your BMW is equipped with two turn signal lamps per side in the front. Turn signal lamp 1 21-watt bulb, WY21SV Controls Reference Mobility 213 Communications Entertainment Navigation Driving tips The illustration shows the front right side of the engine compartment. 1. Press the lever shown: > downward for the right turn signal > upward for the left turn signal High beams, parking lamps The illustration shows the front left side of the engine compartment. High beams 55-watt bulb, H 7 1. Remove the cover cap 1 by pressing the tab and removing the cover cap upward. 2. Press the bulb holder from above to release it. 3. Remove the bulb holder. 4. Remove and replace the bulb. The lamp H7 is pressurized; wear eye protection and protective gloves. Otherwise, there is a danger of injuries if the bulb is accidentally damaged during replacement.< 2. Remove the bulb holder towards the rear. 3. Remove and replace the bulb. Turn signal lamp 2 21-watt bulb, WY21SV The bulb for the turn signal lamp 2 can be replaced via the wheel well. The illustration shows the front left side of the vehicle. 1. Turn the steering all the way to be able to remove the cover, refer to illustration. 2. Turn off the light, switch off the ignition and remove the remote control from the ignition lock. 3. Unscrew the two bolts with an open-ended wrench. Parking lamps 10-watt bulb Bulb holder and reflector are one unit and are replaced together.< 1. Turn the bulb holder 2 to the right and remove. 2. Press the snap connection on the plug connector, pull off the bulb holder and replace. Online Edition for Part no. 01 41 0 013 312 - © 02/07 BMW AG At a glance