Whirlpool WGD86HEBW Dimension Guide
Whirlpool WGD86HEBW Manual
View all Whirlpool WGD86HEBW manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool WGD86HEBW manual content summary:
- Whirlpool WGD86HEBW | Dimension Guide - Page 1
, WGD96HEA Front view: 27" (686 mm) 381/8" (968 mm) Gas Dryer Side view: 3/4"* (18 mm) Back view: 61/4" (159 mm) Recommended Installation Spacing: Water inlet (Steam Models Only) 53/4"* (146 mm) Vent 297/8"* (759 mm) 31/2"* (89 mm) Gas 3/4"* (18 mm) 143/8" (365 mm) 61/8"* (156 mm) 253 - Whirlpool WGD86HEBW | Dimension Guide - Page 2
larger tubing should be used. Pipe-joint compounds resistant to the action of L.P. gas must be used. An individual manual shutoff valve must be installed within 6 ft (1.8 m) of the dryer in accordance with the National Fuel Gas Code ANSI Z223.1. ELECTRICAL REQUIREMENTS A 120-volt, 60 Hz, AC-only, 15
Gas Dryer
PRODUCT MODEL NUMBERS
Front view:
Side view:
Back view:
Recommended Installation Spacing:
Installation spacing for recessed area or closet installation
The dimensions shown below are for the recommended spacing for this dryer.
■
Additional spacing should be considered for ease of installation and servicing.
■
Additional clearances might be required for wall, door, and floor moldings, and dryer venting.
■
Additional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer.
■
For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are acceptable.Companion appliance spacing should also
be considered.
W10558994
01/2013
WGD70HEB, WGD80HEB, WGD86HEB,
WGD88HEA, WGD94HEA, WGD96HEA
27"
(686 mm)
3
/
4
"*
(18 mm)
38
1
/
8
"
(968 mm)
6
1
/
4
"
(159 mm)
29
7
/
8
"*
(759 mm)
3
1
/
2
"*
(89 mm)
5
3
/
4
"*
(146 mm)
6
1
/
8
"*
(156 mm)
14
3
/
8
"
(365 mm)
25
3
/
4
"
(654 mm)
3
/
4
"*
(18 mm)
NOTE:
Most installations require a minimum of 5" (127 mm) clearance
behind dryer for exhaust vent with elbow. See “Venting Requirements”.
18" min.
(457 mm)
1"
(25 mm)
5"
(127 mm)
24 in.
2
min.
(155 cm
2
)
48 in.
2
min.
(310 cm
2
)
3"
(76 mm)
3"
(76 mm)
1"
(25 mm)
*
0" (0 mm) spacing is allowed.
Gas
Water inlet
(Steam Models Only)
Vent