Viking RDDB301SS Installation Instructions
Viking RDDB301SS Manual
 |
View all Viking RDDB301SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Viking RDDB301SS manual content summary:
- Viking RDDB301SS | Installation Instructions - Page 1
Installation Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Website at vikingrange.com UL C UL F20886 EN (040312) 201/301 Series Built-In Dishwashers - Viking RDDB301SS | Installation Instructions - Page 2
Service & Registration 18 2 IMPORTANT- Please Read and Follow • Before beginning-please read these instructions completely and carefully. • DO NOT remove permanently affixed labels, warnings, or rating plates from the dishwasher to the product. Wiring the dishwasher with more voltage than it is - Viking RDDB301SS | Installation Instructions - Page 3
instructions, can result in death, fire or electrical shock. WARNING TIP OVER HAZARD • DO NOT use dishwasher before servicing or installing unit. DO NOT use an extension cord for this appliance. water or moisture. • Viking Range Corporation will NOT warranty any problems resulting from GFI outlets - Viking RDDB301SS | Installation Instructions - Page 4
is required for water supply and discharge lines. D3 26-3/8" (67.0 cm) 23-5/8" (60.0 -heating element rating Inlet water temperature Built-In Dishwasher 201 Models 23-7/8" (60.6 cm) 301 Models 120°F (49°C) required Inlet water pressure operating range Inlet water hose Drain hose Drain hose high - Viking RDDB301SS | Installation Instructions - Page 5
sink compartment before moving the dishwasher into place. 8 Electrical Connections Grounding Instructions This appliance must be grounded. In the circuit breaker or fuse box before servicing or installing unit. DO NOT use an extension cord for this appliance. WARNING Improper connection of the - Viking RDDB301SS | Installation Instructions - Page 6
on its back. Note: Be careful not to pinch hoses or power cord beneath dishwasher. Remove bottom pan. Note: Rapid removal of the bottom pan will cause damage to the moisture sensor. For installation and servicing, slowly pull the bottom pan from the unit and disconnect the wire from the moisture - Viking RDDB301SS | Installation Instructions - Page 7
the kick plate brackets. Screws for the brackets will already be in the base. Note: Be careful not to pinch hoses or power cord beneath dishwasher. 3 1 2 To adjust the depth of the kick plate, loosen screws on the bracket and position in the required depth. Tighten screws and repeat for other - Viking RDDB301SS | Installation Instructions - Page 8
Leveling 7a Equal distance 7b Equal distance DOWN DOWN UP UP DOWN UP 1 OWN 2 UP For 301 models, place a level on handle, then adjust to appropriate height. Left and right adjust side to side and center adjusts front to back. 8 For 201 models, remove front panel to access the front - Viking RDDB301SS | Installation Instructions - Page 9
checks: h Remove packaging and parts. h Turn on the water supply and check for leaks. h Turn the power on at breaker/fuse box and test the dishwasher operation by running a rinse and hold cycle. (This should take about 12 minutes.) h Turn off the electrical power and check for leaks under the - Viking RDDB301SS | Installation Instructions - Page 10
replacement parts may be used in performing service on the appliance. Do not repair or replace any part of the appliance unless specifically recommended in the manual. All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
 |
 |
201/301 Series
Built-In Dishwashers
Installation
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information, call 1-888-VIKING1 (845-4641)
or visit the Viking Website at vikingrange.com
F20886 EN
(040312)
U
L
C
U
L