URC Vivido-RF-Receptacle Owners Manual

RF Split Control Duplex Receptacle

Wireless Control System – VL-9505-RFR-X

Installation Instructions

Important:

Turn circuit breaker OFF or remove fuse(s)

and test that power is off.

Caution:

Use only copper wire with this device. This

device must be properly grounded.

Connect green or

bare grounding wire from box to green-colored wire

from device. To be installed by an electrician or qualified

person in accordance with electrical codes.

To install:

Connect wires per wiring diagram as follows:

• Remove pre-stripped insulation on device wires.

• Strip wires in box 1/2”.

• Twist ends of stripped wires together as per schematic.

• Twist on wire connectors clockwise until secure.

• Connect green ground wire to bare wire, and mount to

box with screws.

After completing successful installation LED on device

will blink until programmed.

For detailed programming

instructions for your receptacle, refer to your controller

manual.

(Ground) Green

Hot

Black

Neutral

White

RF (Controlled)

Non RF

FEDERAL COMMUNICATIONS COMMISSION

INTERFERENCE STATEMENT

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1:

This device may not cause harmful interference, and

2:

This device must accept any interference received,

including interference that may cause undesired

operation.

NOTE:

This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules.

These limits are

designed to provide reasonable protection against

harmful interference in a residential installation.

This

equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications.

However, there

is no guarantee that interference will not occur in a

particular installation.

If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and

receiver.

•

Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV

technician for help.

FCC CAUTION:

Any changes or modifications not

expressly approved by the manufacturer could void the

user’s authority to operate the equipment.

IS-RFTR9505-U-EN (REV. A)

Universal Remote Control, Inc.

500 Mamaroneck Ave.

Harrison, NY 10528

(914) 835-4484

[email protected]

www.UniversalRemote.com

URC Vivido-RF-Receptacle Owners Manual

URC Vivido-RF-Receptacle Manual

URC Vivido-RF-Receptacle manual content summary: