Sony SFM1 Installation Manual
Sony SFM1 Manual
 |
View all Sony SFM1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Sony SFM1 manual content summary:
- Sony SFM1 | Installation Manual - Page 1
INSTALLATION MANUAL SFM1 Sony Electronics, Inc. 16540 West Bernardo Drive San Diego, CA 92127 www.sony.com - Sony SFM1 | Installation Manual - Page 2
PBL-110 Projector Mount Page 2 Installation Manual - Sony SFM1 | Installation Manual - Page 3
The Wall Plate To The Wooden Studs ...12 Securing The Wall Plate To A Concrete Wall ...13 Securing The Flat Panel To The Wall Mount ...14 Lateral Shift Adjustment ...14 Security Cable ...15 Technical Specifications ...16 Warranty ...17 Customer Support ...17 Notes ...18 Installation Manual Page - Sony SFM1 | Installation Manual - Page 4
WALL STRUCTURE MUST BE CAPABLE OF SUPPORTING AT LEAST FIVE (5) TIMES THE WEIGHT OF THE DISPLAY. IF NOT, THE WALL STRUCTURE MUST BE REINFORCED. PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN, AS OUTLINED IN THE INSTALLATION INSTRUCTIONS Contact Sony Electronics to the mounting surface. - Sony SFM1 | Installation Manual - Page 5
SFM1 Parts List NOTE: This wall mount is shipped with all proper installation hardware and components. Make sure that none of these parts are missing and/or damaged before beginning installation. If there are parts missing and/or damaged, please stop the installation and contact Sony Electronics - Sony SFM1 | Installation Manual - Page 6
SFM1 Flat Panel Mount Location WARNING: INVERT THE FLAT PANEL PLACE IT Mount Mounting Bracket Positioning 1. Install the nylon spacers to the mounting points on the flat panel (Figure 3) 2. Lay the left and right mounting brackets (stamped arrows facing out) (Figure 4). Page 6 Installation Manual - Sony SFM1 | Installation Manual - Page 7
SFM1 Nylon Spacers, If Applicable (See Chart) Center Mark Inverted Flat Panel Figure 3. Mounting Bracket Positioning Mounting Brackets Arrows Facing OUT Bottom of Flat Panel Installation Manual Figure 4. Mounting Bracket Installation Page 7 - Sony SFM1 | Installation Manual - Page 8
NOTE: SFM1 The mounting guides are designed with a center viewing guide on the side of them. There will be a "notch" cut on the side of the bracket (Figure 5). Mounting Bracket Center of Flat Panel Bottom of Flat Panel Center of Viewing Guide Figure 5. Locating the Center of the Flat Panel 3. - Sony SFM1 | Installation Manual - Page 9
a ¾" gap on both mounting brackets as shown on this diagram. CAUTION: Do not over tighten the mounting hardware. Phillips Screw Driver DIMPLES FACING UP DIMPLES FACING UP DIMPLES FACING DOWN Bottom Flat Panel DIMPLES FACING DOWN 3/4" Installation Manual Figure 8. Griplate™ Attachment Page - Sony SFM1 | Installation Manual - Page 10
SFM1 Wood Stud Location 1. Using a stud finder, locate the 16" or 24" stud centers behind the wall. 2. Once found, make a pencil mark on the center of the wood studs (Figure 9). NOTE: The wall plates have three 16" and 12" mounting slot positions. Stud Finder Wooden Studs 16" Wooden Studs behind - Sony SFM1 | Installation Manual - Page 11
line and mark the four (4) lag bolt mounting points through the wall plate slots on the wall. 2. Level the wall plate with the reference arrow pointing up to the ceiling (Figure 11). Wall Plate 16" Mounting Slots Level Wood Studs Figure 11. Marking the Mounting Points Installation Manual Page 11 - Sony SFM1 | Installation Manual - Page 12
SFM1 3. Use the information below when mounting to the following surfaces (Figure 12): Wood Studs: Drill four (4) ¼" pilot holes to the marked wall. Concrete Wall: Drill four (4) 3/8" pilot holes to the marked wall Drill Gun Pilot Holes 16" Figure 12. Mounting Surfaces Securing the Wall Plate to - Sony SFM1 | Installation Manual - Page 13
SFM1 Securing the Wall Plate to a Concrete Wall 1. Level and secure the plate to the wall with the reference arrow facing up to the ceiling. 2. Use diameter of 5/16" x 2 ¼"" long wedge anchors. 5/16" x 2 ¼" Wedge Anchors (4ea) Wall Plate Figure 14. Concrete Installation nstallation Manual Page 13 - Sony SFM1 | Installation Manual - Page 14
SFM1 Securing the Flat Panel to the Wall Mount WARNING: At least (2) qualified personnel are strongly recommended for installation of this product. Failure to do so could result in serious injury and possible damage to the flat panel. 1. Raise the flat panel with the LEFT and RIGHT mounting brackets - Sony SFM1 | Installation Manual - Page 15
SFM1 Security Cable 1 2 3 4 Installation Manual Page 15 - Sony SFM1 | Installation Manual - Page 16
Specifications 28.000 (171.2) 16.000 (406.4) CL 5.000 3.500 (127) (88.9) H SFM1 1.245 (31.75) A B CL 21.790 (553.4) A. Wall plate B. Mounting brackets C. Griplate™ D. Mounting 553.4) 5.000 (127) E F C D 1.943 (49.3) B A F Figure 17. Technical Specifications Page 16 Installation Manual - Sony SFM1 | Installation Manual - Page 17
results in damage to mounts, adapters, display equipment or personal injury. Customer Support In the event of missing and/or damage equipment, or technical questions, the following information can help in the completion of the installation. Customer Service 877-350-3477 Installation Manual Page 17 - Sony SFM1 | Installation Manual - Page 18
SFM1 Notes ©Sony 2005 Page 18 Sony Electronics, Inc. 16540 West Bernardo Drive San Diego, CA 92127 (800) 222-7669 www.sony.com Installation Manual
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
 |
 |
INSTALLATION MANUAL
SFM1
Sony Electronics, Inc.
16540 West Bernardo Drive
San Diego, CA 92127
www.sony.com