Sealey SB99.KIT Instruction Manual

SODA BLASTING CONVERSION KIT FOR SB997

& SB998

MODEL NO:

SB99.KIT

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,

and properly maintained, give you years of trouble free performance.

1. SAFETY

±

WARNING!

Turn off, or disconnect from, air supply before servicing or performing any maintenance and when unit is not in use.

Failure to comply with this instruction may damage the unit and will invalidate your warranty.

±

WARNING!

Wear approved ear, eye, hand and respiratory protection when operating the blaster. A full range of personal safety

equipment is available from your Sealey stockist.

9

Spillages of abrasive material, which may be slippery, must be cleaned up immediately to avoid injury.

9

Replace or repair damaged parts. Use recommended parts only. Non-authorised parts may be dangerous and will invalidate the

warranty.

9

Remove ill fitting clothing. Remove ties, watches, rings, other loose jewellery and contain long hair.

9

Always keep the blast nozzle directed at the workpiece.

9

Keep all other persons away from the working area. Contact with high pressure blast or inhaling the dust generated is dangerous.

8

DO NOT

operate the blaster if any parts are missing or damaged as this may cause failure and/or personal injury.

NOTE: This manual is only for the soda blasting conversion kit. For full safety, assembly and operating instructions please refer

to the manual for SB997, SB998.

2. INTRODUCTION

S

oda blasting accessory for use in conjunction with Model No’s SB997 and SB998 Shot Blasters. Quick and simple to fit and use. Soda blasting

is especially suitable in the classic car market as soda will not etch glass and will not warp or remove metalwork. Surface will be left smooth.

Soda also leaves a rust inhibitor behind for up to six weeks.

3. ASSEMBLY

±

WARNING! Before operating the unit ensure you read, understand and apply Section 1 Safety Instructions.

3.1.

REMOVE THE STANDARD MANIFOLD

3.1.1.

Use a screwdriver to loosen the hose clamp on the blasting hose and pull the hose off the connector (fig.1A).

3.1.2.

Unscrew the air hose form the manifold (fig.1B).

3.1.3.

Unscrew the manifold from the bottom of the tank (fig.1C).

3.2.

FIT SODA BLASTING MANIFOLD

NOTE:

Use PTFE tape on threaded connection for an air tight seal.

3.2.1.

Screw in the new manifold until tight, use a spanner (fig.2A), ensure the air hose connection faces the back of the tank.

3.2.2.

Screw in the air hose and tighten with a spanner (fig.2B).

3.2.3.

Push the blasting hose onto the lower connector, tighten the clamp with a flat head screwdriver.

3.2.4.

If the exhaust hose is not connected push it onto the remaining connector (fig.2C).

Refer to

instruction

manual

SB99.KIT

Issue:2 (H,F) 17/06/22

Original Language Version

© Jack Sealey Limited

fig.1

fig.2

Wear ear

protection

Wear eye

protection

Wear protective

gloves

Wear a mask