Pyle UPT210 Instruction Manual
Pyle UPT210 Manual
 |
View all Pyle UPT210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Pyle UPT210 manual content summary:
- Pyle UPT210 | Instruction Manual - Page 1
High Performance Professional Audio MODEL:PT110/PT210 PA AMPLIFIER www.pyleaudio.com - Pyle UPT210 | Instruction Manual - Page 2
of other installations. Please read this manual throughly before you attempt to set up and use the amplifier. It contains a range of installation suggestions as well as instructions to ensure safe usage. Installed properly, you can expect years of trouble-free service from this product. FEATURES AND - Pyle UPT210 | Instruction Manual - Page 3
FRONT PANEL - PT110/PT210 2. Phone Jack Connect a pair of stereo headphones for private listening or cueing (monitoring) sound prior to 'airing' it. 3. MIC 1 & MIC 2 Jack Allows you to connect up to two 6.35mm type microphone. 4. LED Level Display Meter 5. Three Input Sources Mixing Controls - Pyle UPT210 | Instruction Manual - Page 4
REAR PANEL - PT110/PT210 9.Voltage Switch The amplifier has selectable input voltage from 110V/60Hz which is the standard in USA and CANADA. You can also switch the input voltage to 220V/50Hz for EUROPEAN operation. Please make sure the switch is in the proper position before operating, otherwise - Pyle UPT210 | Instruction Manual - Page 5
Connecting microphones The MIC 1 and MIC 2 jacks permit you to connect two microphones with 6.35mm plug. Connecting a CD or tape player, or tuner In this Situation, set the PHONO and AUX/CD SELECTOR switch to the AUX/CD To begin with, in order to ensure equal volume from each speaker, all connected - Pyle UPT210 | Instruction Manual - Page 6
NOTE: ADDITIONAL SPEAKERS MAY BE INCLUDED IN SERIES, BUT IT IS NECESSARY TO CALCULATE TOTAL IMPEDANCE, AND CONNECT THE SPEAKER CIRCUIT TO A TERMINAL OF APPROPRIATE IMPEDANCE. FOR EXAMPLE, IF THREE SPEAKERS OF 4-OHM ARE USED, TOAL IMPEDANCE IS 12 OHMS, YOU SHOULD CONNECT TO THE 16-OHM TERMINAL. - Pyle UPT210 | Instruction Manual - Page 7
See the chart below for some samples system suggestions: COMBINATION OF ONE SERIES PAIR AND ONE PARALLEL PAIR IN PARALLEL SERIES TO ONE SPEAKER PAIR (net impedance) PARALLEL TO ONE SPEAKER PAIR (net impedance) TOTAL IMPEDANCE Use this COMBINING TWO amp PAIRS IN PARALLEL terminal 8-OHM + 8-OHM 8- - Pyle UPT210 | Instruction Manual - Page 8
THE VEHICLE USING FOR THIS POWER SOURCE MUST HAVE A NEGATIVE GROUND ELECTRICAL SYSTEM. IF YOU ARE NOT SURE OF IT, PLEASE CHECK WITH YOUR VEHICLE'S DEALER. Turning the amplifier on 1.Turn on the audio input source equipment which is connected to the amplifier INPUT jack. 2.Set all volume levels (
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
MODEL:PT110/PT210
PA AMPLIFIER
High Performance Professional Audio
www.pyleaudio.com