Poulan PR675Y22RHP Owner Manual

Poulan PR675Y22RHP Manual

Poulan PR675Y22RHP manual content summary:

  • Poulan PR675Y22RHP | Owner Manual - Page 1
    TROUBLESHOOTING (continued) See appropriate section in manual unless directed to an authorized Service Center. PROBLEM CAUSE CORRECTION Grass catcher 1. Cutting height too low. not filling 2. Lift on blade worn off. (If so equipped) 3. Catcher not venting air. 1. Raise cutting height. 2.
  • Poulan PR675Y22RHP | Owner Manual - Page 2
    sandals. Always wear substantial footwear with good ankle 2 support while mowing. TROUBLESHOOTING See appropriate section in manual unless directed to an authorized Service Center. PROBLEM CAUSE CORRECTION Does not start 1. Dirty air filter. 2. Out of fuel. 3. Stale fuel. 4. Water in fuel
  • Poulan PR675Y22RHP | Owner Manual - Page 3
    of this manual). NOTE parts such as carburetor, fuel filter gasoline will cause problems. • If possible blade when crossing gravel surfaces. • Do not operate the mower without proper guards, plates, grass catcher or other safety protective devices in place. • See manufacturer's instructions trouble
  • Poulan PR675Y22RHP | Owner Manual - Page 4
    with manufacturer's recommended parts, when necessary. • Mower blades are sharp and can cut. Wrap the blade(s) or wear gloves, and use extra caution when servicing them. • Do not change the engine governor setting or overspeed the engine. • Maintain or replace safety and instruction labels, as
  • Poulan PR675Y22RHP | Owner Manual - Page 5
    blade. 7. Return mower to upright position. 8. Reinstall rear baffle screws. ENGINE CARBURETOR The carburetor has been preset at the factory. • The air filter must be assembled to the carburetor when running engine. See the ADJUSTMENT section of your engine manual for further instructions MODELS
  • Poulan PR675Y22RHP | Owner Manual - Page 6
    the Service Lower handle and Adjustments section of this manual. NOTE the pulley end of the blade adapter. 10. Reattach drive MODELS: Belt retainer Belt keepers Drive belt 22PLUS REAR WHEEL DRIVE MODELS: 1. Remove screws securing rear baffle. 2. Turn lawn mower on its side with air Tab filter
  • Poulan PR675Y22RHP | Owner Manual - Page 7
    • Turn lawn mower on its side with air filter and carburetor down. • Reinstall blade and blade adapter. 4. Pivot idler arm assembly to slacken rope guide. • Tighten T-knob. INSTALL REAR WHEELS ("HIGH WHEEL" MOWERS ONLY) Some high wheel models require washers which will be provided in a parts bag.
  • Poulan PR675Y22RHP | Owner Manual - Page 8
    a spark plug boot is packed loose in the parts bag. If your model has the boot, install on spark plug wire and reconnect spark plug wire to spark plug. Spark plug Catcher frame hook 8 Boot SERVICE AND ADJUSTMENTS REAR WHEEL DRIVE MODELS: MODELS WITH IDLER ASSEMBLY: • Disconnect spark plug wire
  • Poulan PR675Y22RHP | Owner Manual - Page 9
    SERVICE AND ADJUSTMENTS TO REMOVE / REPLACE DRIVE BELT FRONT WHEEL DRIVE MODELS: "STANDARD" OR "DUAL BAIL" MODELS: • Remove drive cover. Remove belt from gearcase pulley by pushing down on pulley and rolling belt off it. • Turn lawn mower on its side. See engine manual for proper direction of
  • Poulan PR675Y22RHP | Owner Manual - Page 10
    SLOW TO ADJUST CUTTING HEIGHT ALL MODELS: Adjust cutting height to suit your same cutting height. "MANUAL" ADJUSTMENT • Remove wheel SERVICE AND ADJUSTMENTS CAUTION: Before performing any service or adjustments: • Release operator presence control bar. • Make sure the blade and all moving parts
  • Poulan PR675Y22RHP | Owner Manual - Page 11
    leaks are present, start engine (as described in the Operation section of this manual) and let engine run until the underside of the lawn mower is clean. life. 8. Start engine (as described in the Operation section of this manual) and let engine run for a full minute to remove excess water from
  • Poulan PR675Y22RHP | Owner Manual - Page 12
    REAR DISCHARGE ONLY" MOWERS Some models have a seperate mulcher plug, other models have the mulcher plug built into air filter every 100 hours of operation or every season, whichever occurs first. Service air cleaner more often under dusty conditions. See the maintenance section of your engine manual
  • Poulan PR675Y22RHP | Owner Manual - Page 13
    instructions supplied with balancer.) NOTE: Do not use a nail for balancing blade. The lobes of the center hole may appear to be centered, but are not. • Slide blade do not turn freely, contact your nearest authorized service center. 18" (45cm) HI-VAC MODELS ONLY: 1. Remove hubcaps (if equipped) and
  • Poulan PR675Y22RHP | Owner Manual - Page 14
    door Discharge deflector "REAR DOOR PROP" (IF EQUIPPED) (22PLUS MODELS ONLY) NOTE: Rear door will remain open until operator presence control Make sure air filter and carburetor are up. 3. Use a wood block between blade and mower housing to prevent blade from turning when removing blade bolt. NOTE
  • Poulan PR675Y22RHP | Owner Manual - Page 15
    instructed in this manual. Some adjustments will need to be made periodically to properly maintain your unit. All adjustments in the Service and Adjustments section of this manual should be checked at least once each season. • Once a year, replace the spark plug, clean or replace air filter MODELS)
  • Poulan PR675Y22RHP | Owner Manual - Page 16
    when emptying; it will cause unnecessary wear. Handle 21" (53cm) HI-VAC MODELS: Your lawn mower was shipped ready to be used as a mulcher. To trash. See "CLEANING" in the Maintenance section of this manual. • The special mulching blade will recut the grass clippings many times and reduce them
  • Poulan PR675Y22RHP | Owner Manual - Page 17
    manual packed with your CAUTION: The mower blade models equipped with choke feature). • If your mower has a primer, to start a cold engine, push primer as many times as instructed in the engine manual engine while in storage. To avoid engine problems, the fuel system should be emptied before
  • Poulan PR675Y22RHP | Owner Manual - Page 18
    the risk of blade contact injury. Do not under any circumstances attempt to defeat the function of the operator control. The blade turns when the push the mower forward slightly to disengage drive wheels. FRONT WHEEL DRIVE MODELS ONLY: • To keep drive control engaged when turning corners, push down
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18

Grass catcher
1.
Cutting height too low.
1. Raise cutting height.
not filling
2. Lift on blade worn off.
2. Replace blade.
(If so equipped)
3. Catcher not venting air.
3. Clean grass catcher.
Hard to push
1. Grass is too high or wheel
1. Raise cutting height.
height is too low.
2. Rear of lawn mower
2. Raise rear of lawn mower
housing or cutting blade
housing one (1) setting
dragging in grass.
higher.
3. Grass catcher too full.
3. Empty grass catcher.
4. Handle height position not
4. Adjust handle height to suit.
right for you.
Loss of drive
1. Belt wear.
1. Check/replace drive belt.
or slowing of
2. Belt off of pulley.
2. Check/reinstall drive belt.
drive speed
3. Drive cable worn or broken.
3. Replace drive cable.
4. “Loose” drive control system.
4. Adjust drive control.
PROBLEM
CAUSE
CORRECTION
See appropriate section in manual unless directed to an authorized
Service Center.
TROUBLESHOOTING
(continued)
SELF-PROPELLED ROTARY
LAWN MOWER
115 58 78-27 Rev. 6
12.12.16
BY
Printed in U.S.A.