Pioneer W205R Operating Instructions
Pioneer W205R - Dual Cassette Deck Manual
 |
UPC - 012562313429
View all Pioneer W205R manuals
Add to My Manuals
Save this manual to your list of manuals |
Pioneer W205R manual content summary:
- Pioneer W205R | Operating Instructions - Page 1
STEREO DOUBLE CASSETrE DECK CT-W205R Ill_I- _,c] w m _,,- I-jol-li:i:i:i • Illustration shows U.K. model Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your unit properly. After you have finished reading the - Pioneer W205R | Operating Instructions - Page 2
_f your purchased prndu_;tis WcV,bed v_h a polerised power ping, pleaseread tbe foliowinp instructions. This product is equipped hevin_ one bladewider than the SF.IRVIC_NG- The user shouldnot attempt to service the appliancebeyondthat describedld tbe opersting instructions. All other servising - Pioneer W205R | Operating Instructions - Page 3
tested installed and used in accordance with the instructions, may cause harmful interference to radio off and on, the user is encouraged to try to correct the interference by one or more of the audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. Now - Pioneer W205R | Operating Instructions - Page 4
your nearest PIONEER authrized service center tape until the cleaning fluidhas driedcompletely(abouttwo or three minutes). DEMAGNETIZING THE HEADS After using the cassette deck instructions, refer to the operating instructions of the head demagnetizer. I CLEANING THE FRONT PANEL I Clean the deck - Pioneer W205R | Operating Instructions - Page 5
not operate correctly. NOTES: • The accidental erasure prevention tab for each side is the one located on the fop left when the side that you want to protect is facing you. • When breaking off the tab, do not use a magnetized screwdriver. I AUTOMATIC TAPE SELECTOR FUNCTION 1 This cassette deck is - Pioneer W205R | Operating Instructions - Page 6
Pioneer system remote control unit. If the remote control unit does not have separate buttons for deck I and deck II, or a selection button to choose deck ( or deck II, the buttons will only operate deck I1. To operate deck I with a remote control unit which was not designed for double deck cassette - Pioneer W205R | Operating Instructions - Page 7
pressing this button. NOTE: /f the power is turned off while the tape is moving, the cassette door may remain locked./n this case, turn the power on before pressing the eject (A) button. _) Deck I operation buttons _1 : Reverse playback I_ : Forward playback - Pioneer W205R | Operating Instructions - Page 8
is performed on one side of the tape only. When the tape reaches the end Deck I and II are loaded with tapes, each tape will be played using relay pal/back. OPERATION OF DECK I WITH A REMOTE CONTROL UNIT NOT DESIGNED FOR DOUBLE DECKS (System remote control) Selecting DECK I In order to operate DECK - Pioneer W205R | Operating Instructions - Page 9
I TAPE TRANSPORTATION MODE INDICATOR,S - Pioneer W205R | Operating Instructions - Page 10
was used for recording. 3. Set the REV MODE switch (see page 8). 4. Set the stereo amplifier for tape playback. 5. Press the playback II_ or - Pioneer W205R | Operating Instructions - Page 11
MS- button as many times as the number of songs to be skipped plus one. From the stop mode Pressthe MS+ or - button to pedorm music searchas mentioned • When using tapes with noise in the blanks between selection. How Selections are counted When starting the music search operation from the middle - Pioneer W205R | Operating Instructions - Page 12
is due to differences in tape sensitivity, and creates no problem. I RECORDING MUTE Use this function to create the 4.5-second blanks needed for proper operation of the music search function. • Press the recording mute (0) button during recording and the deck will create a blank space by recording - Pioneer W205R | Operating Instructions - Page 13
• During high-speed copying, none of the operation buttons wi// function except for the stop Jl) button. • Duringnormalspeedcopying, therecordingmutefO)and pause (ll)buttons of deck II also function. • Tape copying is cence//ed when either of the two tapes reaches the end. Therefore it is advisable - Pioneer W205R | Operating Instructions - Page 14
another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exemising the checks listed below, ask your nearest PIONEER authodzed service center or your dealer to carry out repair work. Symptom POWER Cause Remedy Cannot - Pioneer W205R | Operating Instructions - Page 15
when recording (see page 12). • Replace the cassette. • Clean the heed (see page 4). O High noise tape is being used. e Incomplete insertion of a connection by static electricity, or other external interference. To restore norms/operation, turn the power off and then on again, or unplug the AC - Pioneer W205R | Operating Instructions - Page 16
stereo Heads"Hard Permalloy" recording/playback head x 1 "Hard Permalloy" p_ayback head x 1 "Ferrite" erasing head x 1 Motor DC senlo motor x 2 Wow and Flutter 0.09% (WRMS) ==0.19% (DIN) Fast Winding Time Approximately 100 seconds (C-60 tape -speed copy (DECK I --_ DECK II) • PIONEER
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
STEREO
DOUBLE
CASSETrE
DECK
CT-W205R
Ill_
I-
_,c]
w
m
_,,-
I-jol-li:i:i:i
•
Illustration shows
U.K.
model
Thank
you
for buying this
Pioneer
product.
Please read through these operating
instructions
so
you will
know
how to operate your unit properly. After you have fin-
ished
reading
the instructions,
keep
them in a safe place
for
future reference.
In some countries or regions, the shape of the power
plug
and power outlet
may
sometimes
differ from that shown in
the
explanato_
drawings. However, the
method
of connect-
ing and operating the unit is the same.
WARNING:To
PREVENT
FIRE
OR SHOCK
HAZARD,
DO
NOT EXPOSE
THIS
APPLIANCE
TO
RAIN OR MOIS-
TURE.
THE
POWER
SWITCH
IS SECONDARY
CONNECTED
I
AND
THEREFORE
DOES
NOT
SEPARATE
THE
UNIT
FROM MA NS POWER
N THE STANDBY
POS T ON.
product
I
This
complies with
the Low
Voltage Directive {73/23/I
EEC),EMC Directives(89/336/EEC,
92/31/EEC}
and
CEMarking
Directive
(93/68/EEC).
CAUTION:
TO PREVENT
ELECTRIC
SHOCK DO
NOT
USE THIS
(POLARIZED)
PLUG
WITH
AN EXTENSION
CORD,
RECEPTACLE
OR OTHER
OUTLET
UNLESS
]'HE
BLADES CAN
BE
FULLY INSERTED TO
PREVENT
BLADE
EXPOSURE.
IMPORTANT
NOTICE
The serial
number
for
this
equipment
is located
on the rear
panel. Please write this serial number on your enclosed war-
rent,/card and keep it in
a
secure area. This is
for
your secu-
rity.
ATTENTION:
POUR
PREVENIR
LES
CHOCS
ELECTRIOUES NE
PAS
UTILISER CETTE FICHE POLARISEE
AVEC UN PROLONGATEUR,
UNE PRISE DE COURANT
OU
UNE
AUTRE
SORTIE
DE
COURANT,
SAUF SI
LES LAMES
PEUVENT
ETRE INSEREES
A FOND
SANS
EN LAISSER
AUCUNE
PARTIE A DECOUVERT.
IMPORTANT 1
The
lightning
flash
with
arrowhead,
within
an
_:uil=tml
triangle,
is
intended
to
_
the user to
presence
o,f uninsuiated
=dangerous
_ltage'
with_
the
product's
enclosure
thal
may
be of
sufficient
magnitude
to constitute
a
r_$k
Of electric
shock
to
ponmn$.
CAUTION
CALI'nON:
TO
PREVENT
THE
RISK
OF
ELECTRIC
SHOCK,
DO
NOT
REMOVE
COVER
(OR
SACK),
NO
USER-SER-
VICEABLE
PARTS
INSIOE.
REFER
SESVICING
TO
QUALIFIED
SERVICE
PESSONNEL
PlONEE/ "
The Art of Entettainme
The exclamation
point
within an equilateral
triangle
is
intended
to alerl
the user to the i_esence
of important
operating
and maintenance
Ise _icing_,'_t
ructions
in
the
literature
aCCOmpanying
the
appliance,.