Panasonic D2CD12V50-3 Installation Instructions for fiber Model
Panasonic D2CD12V50-3 Manual
 |
View all Panasonic D2CD12V50-3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Panasonic D2CD12V50-3 manual content summary:
- Panasonic D2CD12V50-3 | Installation Instructions for fiber Model - Page 1
. Additional Information can be found in the operating instructions for the AWHE50 and AWRP50 at the following websites. If you use RS422 for control, no camera configuration is needed. http://www.panasonic.com/business/provideo/support/includes/pdf/OI/AW-RP_OI.pdf http://www.panasonic.com - Panasonic D2CD12V50-3 | Installation Instructions for fiber Model - Page 2
com/products/converters/converters-fido-models.php Technical support: 530-271-3190 SerialComm http://www.serialcomm.com /media_converter/rs232_rs485_rs422 _to_fiber_optic_sm/rs232_rs485_rs422_to_fiber_optic_sm.product_general_info.aspx Technical support: 1-877-218-7964 530-271-3190 553ffff130
-
1 -
2
 |
 |
Installation Instructions for Model #S
D2-CD-12V-50-3
D2-HB-MVP5-50-3
These models allow the camera to be controlled by either IP over fiber or RS422 over fiber or
both.
Connect devices as shown in the test setup diagram. The only devices that need menu
configuration are the Panasonic AWHE50S and AWRP50.
The Panasonic HE50 default video format is 1080i/59.94 and the default IP address is
192.168.0.10. There are 2 ways to configure the HE50, by using the Panasonic AWRP50
controller, or by using the web interface of the HE50.
The web interface method is
recommended if the Ip needs to be set to a specific address. In order for your computer to
communicate with the HE50, it must be set to a static Ip address by method below. No device can
have the same IP address. Once you have access to the web interface, navigate to the
system tab
and change the
video format
to match your system, and the
IP address
to
match your network
environment. See the following pages for Web setting screen instructions. Additional
Information can be found in the operating instructions for the AWHE50 and AWRP50 at the
following websites. If you use RS422 for control, no camera configuration is needed.
For Panasonic AW-HE50 and AW-RP50 technical support please call 800-524-1448
Procedure to set your computer for static IP address
1.
From web browser go to
tools
>
internet options
>
connections
>
lan settings
and uncheck
the
proxy server boxes
.
2.
Go to
control panel
>
network settings
and right click your
lan connection
and select
Properties
Highlight
internet protocol TCP/IP
and click
properties
. Check the,
use
following IP address
and enter 192.168.0.111 and 255.255.255.0 for subnet mask. Click
ok
3.
Type the default IP address of the HE50 into the address bar.
Use the following procedure to test the IP and/or RS422 camera
control using the Panasonic AWRP50.
1.
Connect RP50 as shown in diagram. Be sure to use a cat5 cross cable for IP control.
2.
Press menu button than
#8 button
.
3.
Turn F1 and select
[2] Power
and press
F1
4.
Turn F2
and select
all on
then
press f2
5.
The power LED on the front of the camera should turn green.