Optoma DE-GWII9xxxE V.2 User Manual
Optoma DE-GWII9xxxE V.2 Manual
 |
View all Optoma DE-GWII9xxxE V.2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Optoma DE-GWII9xxxE V.2 manual content summary:
- Optoma DE-GWII9xxxE V.2 | User Manual - Page 1
- Optoma DE-GWII9xxxE V.2 | User Manual - Page 2
NO.1 IMPORTANT SAFETY INSTRUCTIONS Basic safety precautions,including the following should always be or if the motorized screen has been dropped or damaged,until it has been examined by a qualified service technician. Position the cord so that it will not be tripped over,pulled or in contact with not - Optoma DE-GWII9xxxE V.2 | User Manual - Page 3
N0.2 To reduce the risk of electric shock,do not disassemble this appliance,only a qualifid service technician may service or repair motorized screen.Incorrect reassemble can cause electric shock when the motorized screen is used. Only use accessory attachment recommended by the manufacturer.Use - Optoma DE-GWII9xxxE V.2 | User Manual - Page 4
NO.3 Thank you for choosing Panoview screens. All screens have passed the strict quality inspection before delivery. Read this manual carefully to ensure proper usage. Important Attention: the installation of the screen, the electric wire connection, the setting of the limit switches must be made - Optoma DE-GWII9xxxE V.2 | User Manual - Page 5
N0.4 Technical data: Input Voltage: 110VAC/60HZ Output Voltage: 3A Fuse: 1A IR Remote Control Distance: ≤8m, ±15°Horizontal 12V Trigger Jack: OD3.4xID1.3 12V Trigger Signal: Voltage:7---11VAC or 8---16VDC, Current: ≥2mA IR Handset: 1pc Switch control: 1pc Unpack screen carefully, be sure screen is - Optoma DE-GWII9xxxE V.2 | User Manual - Page 6
NO.5 Remove two pulling locks on the bottom slat bar after the case has been installed. Install screen brackets onto ceiling or wall with appropriate hardware. Anchor screen onto bracket as shown in above figure below. MOUNT SCREEN TO WALL MOUNT SCREEN TO CEILING - Optoma DE-GWII9xxxE V.2 | User Manual - Page 7
CONNECTION Internal wiring has been completed at the factory.No addi- tional wiring is necessary. Note:all wiring related to the screen,may only be serviced by a manufacturer approved trained electrical technician.Tampering with electrical wiring may void warranty and release Panoview of liability. - Optoma DE-GWII9xxxE V.2 | User Manual - Page 8
NO.7 OPERATING INSTRUCTION: Plug in power supply. For Switch control: Plug in Switch into switch jack. Press button to Up position, screen goes up. Press button to stop - Optoma DE-GWII9xxxE V.2 | User Manual - Page 9
N0.8 For 12V trigger: Input 12V trigger signal, screen goes down. Stop this signal, screen goes up. Electric lock: Press the Up & Down buttons on the IR handset together, then all Up & Down buttons on the switch and IR handset will be locked. To be unlocked press Stop button on the IR handset again - Optoma DE-GWII9xxxE V.2 | User Manual - Page 10
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
 |
 |
