Macrom M2SW.801 User Manual (Italiano-English)

USER MANUAL

M2SW.801

-2-

Table of contents

Warranty

Safety information

Specifications

Product overview

Product inspallation

Adjust the volume

Product care

3

3

3

4

5

6

6

EN

Specifications

MSW.801 play a music from a RCA line input or from a High level

input.

The operating frequency range is from 30Hz to 120Hz. Output rated

power 250 Watt (80W RMS). Signal to noise ratio > 100dB. Input

sensitivity @1% THD: 160mV /RCA and 4.5V/High level. Max current

consumption 10A. Operation voltage from 9Volts to 15.5Volts.

-3-

Warranty

Thank

you

for

purchasing

this

Macrom

product.

Should

your product need warranty service, please return it to the

shop where you buy it or to the Macrom distributor in your

country.

The

warranty

does

not

cover

damage

due

to

improper

use

and

or

installation,

incorrect

connections

to

power supply and audio video sources, exposure to excessive

humidity,

unauthorized

repair

attempts

or

modifications.

Safety information

Before beginning with installation, disconnect the wire from the

battery ground terminal to prevent any short during installation.

This subwoofer must properly installed by Macrom authorized

installer. Impropers installation may damege the unit and /or the

vehicle. Verify all electrical and drivability of the vehicle before the

installation.

Product overview

Power LED indicator

Fuse

-4-

M2SW.801

Power terminals

RCA line Input

Level Input

Frequency cutting

Protection LED indicator

High level Input

Remote level control

Front panel

Power terminals

DC +12 V Battery

Power remote control

Ground/negative

-5-

Connect the power wires to the terminal block, pay attention to

respect cable polarity indicated on the product.

Connect the signal input according to the selected input (RCA method

1) or (High level method 2).

Adjust the frequency cutting and the level input sensitivity.

Place all the knobs in the center position, and start adjusting the gain

and follows the frequency cutting to optimize the best match vehicle

acoustics.

Product installation

RCA line input method 1

High level input method

2

Follow all mounting and wiring instructions to ensure the integrity of

existing wiring after installation.

Separate Audio and Power wiring to avoid interference.

All wires and connection must be insulated with electrical tape,

and fitted with protective connector shields where ever possible.

Before replacing blown Fuse, check and verify that there is not

short at all connections.

Only use 10A fuse in to the unit.

Adjust the Volume

To adjust the volume while listening to music

turn the volume knob from remote level control.

Please remember that excessive sound pressure

can damage the

speaker.

Product care

Please remember that your Macrom product is an electronic device,

and so needs to be treated with care:

Do not subject it to mechanical shock or vibrations.

Do not subject it to excessive heat.

Keep it away from water and excessively humid areas.

Keep it away from high electromagnetic fields.

There are no user-serviceable parts inside. Opening the product or try

to repair it will terminate the warranty.

The MACROM brand is a registered trademark of ALDINET S.p.A.

w

w

w

.

m

a

c

r

o

m

.

i

t

ALDINET S.p.A

Viale C. Colombo, 8 - 20090 Trezzano s/N (MI) - Itlaly

Tel. +39 02 484781

Declaration of Conformity

Manuale di istruzioni M2SW801_600 ENG-IT.indd

1

18/09/2013

14:40:05

Macrom M2SW.801 User Manual (Italiano-English)

Macrom M2SW.801 Manual

Macrom M2SW.801 manual content summary: