LiftMaster 61LM Instructions - English French

LiftMaster 61LM Manual

Get LiftMaster 61LM PDF manuals and user guides View all LiftMaster 61LM manuals
Add to My Manuals
Save this manual to your list of manuals

LiftMaster 61LM manual content summary:

  • LiftMaster 61LM | Instructions - English French - Page 1
    This will access the dip switches for the ribbed button. 2-Button Remote Controls Tab + 0 - 1 2 3 456 7 8 9 + 0 - 1 2 3 456 7 8 9 + 0 - 1 2 3 456 7 8 9 3-Button Mini Remote Control: The large top button is recommended for use with a garage door opener and/or light control product. The other push
  • LiftMaster 61LM | Instructions - English French - Page 2
    switch in the single or 2-button remote control MUST correspond to the buttons on the 3-button remote control as shown. Example: If you are programming a single-button remote control to the middle button on the 3-button remote control, dip switch #1 in the single-button remote control MUST be set to
  • LiftMaster 61LM | Instructions - English French - Page 3
    /Learn Button 4 Repeat the steps 3-4 above with the yellow button on the remote control and the receiver Smart/Learn button "B" to program the CLOSE mode; and again with the green button on the remote control and the receiver Smart/Learn button "C" to program the OPEN mode. 5 Replace the receiver
  • LiftMaster 61LM | Instructions - English French - Page 4
    receiver and/or remote control are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to REPLACEMENT PARTS Visor clip 29C128 12V battery 10A14 FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 www.liftmaster
  • LiftMaster 61LM | Instructions - English French - Page 5
    61LM et 61LMC Modéles 62LM et 62LMC Modéles 33LM, 33LMC, 63LM, et 63LMC Modéles 64LM et 64LMC Afin d'éliminer les risques de BLESSURES GRAVES ou de MORT découlant de l'actionnement d'une clôture ou d'une porte de garage commerciaux et avec tous les produits LiftMaster® qui utilisent un code fixe à
  • LiftMaster 61LM | Instructions - English French - Page 6
    PROGRAMMATION Utilisez un crayon ou un tournevis pour positionner les commutateurs Dip. Programmation de la télécommande avec une télécommande existante Localisez les commutateurs Dip sur les télécommandes anciennes et nouvelles. Placez les télécommandes côte à côte et positionnez les commutateurs
  • LiftMaster 61LM | Instructions - English French - Page 7
    PROGRAMMATION DU MODÈLE 33LMC UNIQUEMENT Installer le poste de commande et le récepteur là où la porte est visible mais à l'écart de la porte et de ses ferrures de montage. Lorsqu'un récepteur est utilisé pour actionner un ouvre-porte commercial, une bordure d'inversion DOIT être posée au bas de la
  • LiftMaster 61LM | Instructions - English French - Page 8
    AVERTISSEMENT Pince du pare-soleil 29C128 Pile de 12 V 10A14 AVERTISSEMENT POUR OBTENIR DE L'ASSISTANCE TECHNIQUE, COMPOSER NOTRE NUMÉRO GRATUIT : 1-800-528-9131 www.liftmaster.com 114A4172B © 2010 The Chamberlain Group, Inc. Tous droits réservés
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
To prevent possible SERIOUS INJURY or
DEATH from a moving gate or garage door:
•
ALWAYS keep remote controls out of
reach of children. NEVER permit children
to operate, or play with remote control
transmitters.
•
Activate gate or door ONLY when it can be
seen clearly, is properly adjusted, and
there are no obstructions to door travel.
•
ALWAYS keep gate or garage door in sight
until completely closed. NEVER permit
anyone to cross path of moving gate or
door.
INTRODUCTION
This product is for use with gate operators, commercial door operators and any LiftMaster
®
product
that uses a 390 MHz fixed code. The single-button remote control will activate one device, the
2-button remote control will activate up to 2 devices, and the 3-button remote control will activate
up to 3 devices.
Models 61LM & 61LMC
Models 62LM & 62LMC
Models 33LM, 33LMC
63LM, & 63LMC
Models 64LM & 64LMC
Locate the dip switches on your remote control
BEFORE YOU BEGIN
Single-Button and 3-Button Remote Controls:
Slide the battery cover open to access the dip
switches in the remote control.
2-Button Remote Control:
The 2-button remote control has two sets of
dip switches.
Slide the battery cover open to access the dip
switches for the smooth button. Remove the
screw on the back of the remote control and
remove the cover by pressing the tab. This will
access the dip switches for the ribbed button.
3-Button Mini Remote Control:
The large top button is recommended for use with
a garage door opener and/or light control product.
The other push buttons can be used to operate
another garage door opener and/or light control
product.
Access the dip switches by turning the remote
over and removing the back of the case. Be
careful to avoid moving circuit board components.
+
0
–
1
2
3
4
5
6
7
8
9
+
0
–
1
2
3
4
5
6
7
8
9
Tab
1
Single and 3-Button Remote Controls
2-Button Remote Controls
Mini Remote Controls
WARNING:
This product can expose you to chemicals including lead, which are known to
the State of California to cause cancer or birth defects or other reproductive harm. For more
information go to
www.P65Warnings.ca.gov