Humax DVR-9900C User Manual - Page 74

14. Universal Remote Control 3. Checking the programming 1. Switch the TV on again and check whether you can operate the most important functions on you TV using the remote control. Important: You can check all buttons with the exception of the TV button. 2. When the TV control functions work properly, press the TV button for 3 seconds to confirm this programming. Note: Your remote control is now ready to operate your TV. The remote control now operates the audio volume level of your TV and not of the receiver. If you want to continue to adjust the volume level of the receiver, press the KDG and MUTE button for 3 seconds until the TV LED blinks twice. Note: If you cannot operate your TV correctly, switch it on again and repeat points 3 and 4 until the best programming is found. Important: If in spite of doing so you are not successful, or if you were unable to find the manufacturer of your TV, please look at the remote control web page under (www.kabeldeutschland.de/urc). ** 4. Restoring the factory setting Press the TV and 0 buttons on the receiver remote control at the same time. Keep both buttons pressed for 5 seconds to allow the remote control to return to its factory settings. Note: The TV button on the remote control has then no function. To be able to again operate your TV with the receiver remote control, you will need to set up the TV from the start. Note: This process can take several minutes, in some cases up to 15 minutes. During this time, the remote control sends all possible TV signals one after another. Each time a signal is sent by the remote control, the TV LED briefly extinguishes. GB 73