Hotpoint RGBS100DMWW LP Conversion Kit

BURNER OUTPUT RATINGS: BTU/HR

Propane (LP) Gas 10” W.C.P.

BURNER

BTU RATE

ORIFICE SIZE

RF

8,000

#66 (0.033”)

LF

8,000

#66 (0.033”)

RR

8,000

#66 (0.033”)

LR

8,000

#66 (0.033”)

OVEN

16,000

0.048”

CONVERTING THE PRESSURE REGULATOR

CONVERTING THE COOKTOP BURNERS

A.

Lift the burner assemblies straight up (set aside) to gain

B.

Using a 5/16” (8 mm) nut driver or adjustable wrench,

remove each of the four (4) spuds on the surface burner

gas inlet tubes.

Raise the cooktop and locate the pressure regulator. Follow the

directions.

1.

Use an adjustable wrench to unscrew the hex-nut cap from

the pressure regulator.

2.

Turn the plastic cap 1/4 turn to disassemble.

3.

Turn the plastic cap over and hook it into the slots. Rotate

cap 1/4 turn to reassemble. The type of gas to be used

should now be visible on the top of the cap.

PROPANE (LP) CONVERSION INSTRUCTIONS

Rotate cap counter-

clockwise to loosen.

PROPANE

NAT

WARNING

Explosion Hazard

Death or serious injury can result from failure to follow

these instructions.

• Reconnect all grounding devices after service.

• Replace all parts and panels before operating.

NOTICE:

If you are using propane (LP) gas, all adjustments

described in the following steps must be made before you

make any burner adjustments.

NOTICE:

WARNING

Do not operate the cooktop or oven

burners of this range when using propane (LP) gas before

propane (LP) gas use. Failure to do so could cause high

natural gas. To use propane (LP) gas, the regulator and burner

TOOLS REQUIRED:

• Adjustable wrench

• 1/2” Open-end wrench

• Phillips head screwdriver

• Nut drivers: 5/16”, 1/4”

or 8mm

To adjust your range for use with propane (LP) gas, follow

these instructions:

1. Disconnect all electrical power, at the main circuit breaker or

fuse box.

screwed into the gas supply tubes.

conversion back to natural gas.

PROPANE (LP) CONVERSION INSTRUCTIONS

31-11151-1

08-18

GEA

RGBS100 and VGBS100

LP Gas

Silver

Natural Gas

Brass

OR

CONVERTING THE OVEN BURNERS

OVEN BURNER ORIFICE

1.

Remove oven door, broil drawer, oven bottom, and burner.

some models a metal shield must be removed.

one supplied in kit with range.

NOTICE:

This product cannot be converted to propane (LP) by

propane (LP).

NOTICE:

WARNING

The following adjustments must be made

before turning on the gas to the oven burner. Failure to

toxic fumes.

Oven burner

air shutter

Oven

orifice

the back of the range in the location shown.

Propane Conversion Kit

Hotpoint RGBS100DMWW LP Conversion Kit

Hotpoint RGBS100DMWW Manual

Hotpoint RGBS100DMWW manual content summary: