HP Latex 360 Line Sensor Cleaning
HP Latex 360 Manual
 |
View all HP Latex 360 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Latex 360 manual content summary:
- HP Latex 360 | Line Sensor Cleaning - Page 1
HP Latex 100/300/500 Printer Series Line Sensor Cleaning - HP Latex 360 | Line Sensor Cleaning - Page 2
to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors - HP Latex 360 | Line Sensor Cleaning - Page 3
performance issue. Refer to the user guide to clean the sensor or call your HP representative if the problem persists. You should also clean the maintenance cartridge is not detected. ● The printer is unable to read the width of the substrate. Cleaning procedure 1. Turn off the printer and unplug - HP Latex 360 | Line Sensor Cleaning - Page 4
3. Remove the maintenance cartridge by sliding it out. 4. Remove the maintenance cartridge. IMPORTANT: Slide it out horizontally to avoid spills, as it is full of ink. 5. Move the carriage to the right side of the printer to have appropriate access to it from underneath. 2 Line sensor cleaning - HP Latex 360 | Line Sensor Cleaning - Page 5
cartridge back into the printer. 10. Close the door on the right-hand side. 11. Turn on the printer. 12. Perform a printhead alignment to verify that the line sensor is working correctly and repeat the cleaning process if needed. If cleaning the line sensor does not yield results, call your HP
-
1 -
2 -
3 -
4 -
5
 |
 |
HP Latex 100/300/500 Printer Series
Line Sensor Cleaning