GE JK3800SHSS Quick Specs

Listed by

Underwriters

Laboratories

Specification Revised 8/14

For answers to your Monogram

®

or GE

®

appliance

questions, visit our website at geappliances.com

or call GE Answer Center

®

service, 800.626.2000.

JK3800SH

GE

®

27" Built-In Combination Microwave Oven

Note:

Cabinets installed adjacent to wall

ovens must have an adhesion spec of at

least a 194°F temperature rating.

Installation Information:

Before installing,

consult installation instructions packed with

product for current dimensional data.

Door handle protrudes 3" from door face.

Cabinets and drawers on adjacent 45°

and 90° walls should be placed to avoid

interference with the handle.

Electric wall ovens are not approved for

installation with a plug and receptacle.

They must be hard wired in accordance

with installation instructions.

Note:

These ovens are not approved for

stackable or side-by-side installations.

Dimensions and Installation Information (in inches)

KW Rating

240V

6.4

208V

5.6

Breaker Size

240V

30 Amps

208V

30 Amps

Cabinet

27"

A – Overlap of oven at top of cutout

1"

B – Overlap of oven over side of edges of cutout

3/4"

C – Overlap of oven at bottom of cutout

1"

Oven

D – Overall depth with handle

26-3/4"

Overall depth without handle

24-1/2"

E – Overall height with trim

42-3/8"

F

– Overall width

26-3/4"

20" minimum

door opening

allowance

Conduit

48"

C

L

Suitable

bracing

to support

runners

2 x 4 or

equivalent runners

level with bottom of cutout

and flush with sides of cutout

or solid bottom floor.

B

27''

A

C

Cutout width

25" MIN.

25-1/4" MAX.

Recommended

minimum

cutout location

from the floor

21-5/8"

Cutout height

41-1/8" MIN.

41-1/4" MAX.

JK3800

20"

E

F

D

8-3/4"

MAX.

Right side only

Cutout depth

23-1/2"

MIN.

28" MIN. to

bottom of

junction box

Junction box

location

(Junction box

may be located

in adjacent

cabinet)

ATTENTION INSTALLER:

All electric wall ovens must be hard-wired (direct-wired)

into an approved junction box. A plug and receptacle is NOT permitted on these products.

NOTE: If the cabinet does not have a solid bottom,

two braces or runners must be installed to support

the weight of the oven. For single ovens, the runners

and braces must support 200 lbs (91 kg). For double

ovens, the runners and braces must support 375 lbs.

(170 kg).

NOTE: If marks, blemishes or the cutout opening are

visible above the installed oven, it may be necessary

to add wood shims under the runners and front trim

until the marks or opening are covered.

NOTE: If the cabinet does not have a front frame

and the sides are less than 3/4" (1.9 cm) thick, shim

both sides equally to establish the cutout width.

GE JK3800SHSS Quick Specs

GE JK3800SHSS Manual

GE JK3800SHSS manual content summary: