Epson TM-U675 Installation Manual PT-6000

PT-6000/DPR-6000/TA-6000 Installation Manual

Installing the PT-6000

The PT-6000 is an optional tray to hold a TM-H6000/H6000II/H6000III printer, especially

when it is used with an IBM

®

host computer. Because this tray can hold the printer at an angle,

it does not require much space behind it. Therefore, the tray is a valuable space-saving device

for small countertops. The package includes the PT-6000 and 2 sets of affixing tape.

Note:

Before installing the PT-6000, clean any dirt, oil, or other foreign matter off of the countertop or other

surface where the printer will be installed.

Follow the steps below to install the PT-6000. If you are installing the printer on an IBM

469X

series computer with a projection around the host computer, see the other side of this sheet.

1.

With 2 pieces of the affixing tape combined, peel off the stickers on one side of the 2 sets of

combined tape, and paste them to the bottom of the PT-6000.

2.

Peel off the stickers on the other sides of the affixing tapes, and press the PT-6000 onto the

countertop; it will be held firmly in place by the affixing tapes.

3.

Connect the cable and install the printer on the PT-6000, aligning the 4 rubber feet of the

printer with the 4 projections on the PT-6000 shown above.

IBM is a registered trademark of International Business Machines Corporation.

PT-6000

Affixing

tape

Projections

401344201

© 2000 Seiko Epson Corporation. All rights reserved.

Printed in China