Epson EX3260 Warranty Statement

Declaration of Conformity

According to 47CFR, Part 2 and 15, Class B Personal Computers and Peripherals; and/or CPU Boards and Power

Supplies used with Class B Personal Computers

We:

Epson America, Inc.

Located at:

3840 Kilroy Airport Way, MS 3-13, Long Beach, CA 90806

Telephone:

(562) 981-3840

Declare under sole responsibility that the product identified herein, complies with 47CFR Part 2 and 15 of the

FCC rules as a Class B digital device. Each product marketed, is identical to the representative unit tested and

found to be compliant with the standards. Records maintained continue to reflect the equipment being produced

can be expected to be within the variation accepted, due to quantity production and testing on a statistical basis as

required by 47CFR §2.909. Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may

cause undesired operation.

Trade Name:

Epson

®

Type of Product:

Projector

Model:

H842A/H845A

Marketing Name:

EX3260/Pro EX7260

Pro EX7260 Wireless LAN Safety and

Specifications

Contains wireless LAN module model: WN7122BEP

This document provides safety instructions and describes the specifications. Read this document carefully before

use to ensure your safety and product performance.

Data transmission is always initiated by software, which is the passed down through the MAC, through the digital

and analog baseband, and finally to the RF chip. Several special packets are initiated by the MAC. These are the

only ways the digital baseband portion will turn on the RF transmitter, which it then turns off at the end of the

packet. Therefore, the transmitter will be on only while one of the aforementioned packets is being transmitted. In

other words, this device automatically discontinues transmission in case of either absence of information to

transmit or operational failure.

This equipment is restricted to indoor operation only.

U.S. FCC Notices

Contains FCC ID: BKMAE-7122

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one of the following measures:

■

Reorient or relocate the receiving antenna.

■

Increase the separation between the equipment and receiver.

■

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

■

Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate this equipment. Properly shielded and grounded cables and connectors must be used for

connection to host computers and/or peripherals in order to meet FCC emission limits.