Epson ColorWorks CW-C4000 Designer s Guide for the Paper Feeder/Paper Rewinder
Epson ColorWorks CW-C4000 Manual
 |
View all Epson ColorWorks CW-C4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson ColorWorks CW-C4000 manual content summary:
- Epson ColorWorks CW-C4000 | Designer s Guide for the Paper Feeder/Paper Rewinder - Page 1
Paper Feeder/Paper Rewinder Designer's Guide M00144300EN Rev.A - Epson ColorWorks CW-C4000 | Designer s Guide for the Paper Feeder/Paper Rewinder - Page 2
product, or (excluding the U.S.) failure to strictly comply with Seiko Epson Corporation's operating and maintenance instructions. 7. Seiko Epson Corporation shall not be liable against any damages or problems arising from the use of any options or any consumable products other than those designated - Epson ColorWorks CW-C4000 | Designer s Guide for the Paper Feeder/Paper Rewinder - Page 3
Contents ■ Contents...3 ■ Paper Feeder/Paper Rewinder Design Guide 4 Supported Paper ...4 Label Length ...5 Preparation before Use ...6 Paper Feed Speed ...7 Paper Load...8 Paper Curl...8 Paper Angle for Feeding and Ejecting...9 Position of Paper Feeder and Paper - Epson ColorWorks CW-C4000 | Designer s Guide for the Paper Feeder/Paper Rewinder - Page 4
Paper Feeder/Paper Rewinder Design Guide The CW-C4000 Series is designed to print on roll external devices, and perform adequate verification before starting actual printing. Supported Paper The following types of paper are supported when using an external large diameter roll paper feeder and/ - Epson ColorWorks CW-C4000 | Designer s Guide for the Paper Feeder/Paper Rewinder - Page 5
Paper without waste part on left and right sides only ✓ Supported ✓ Supported ✓ Supported ✓ Supported 1. For the latest information on detailed paper specifications and the base paper used in roll paper, contact qualified service personnel. 2. For details on paper without waste part and paper - Epson ColorWorks CW-C4000 | Designer s Guide for the Paper Feeder/Paper Rewinder - Page 6
the Media Source to [External Feed] Set the Media Source to [External Feed]. For details on this setting, refer to the CW-C4000 Series User's Guide. • Do not use [Stop at Peel-Off Position] in the Print Mode. ∗ The printer preforms a back feed operation of a length determined by Print Mode. ∗ If - Epson ColorWorks CW-C4000 | Designer s Guide for the Paper Feeder/Paper Rewinder - Page 7
Set the Printer Driver 1 Click [Advanced] on the [General] tab. 2 Select the check box for [Paper Adjustment] - [Paper Vacuum Manual Adjustment]. 3 Move the slide bar to adjust the vacuum. It is recommended to select [Strong] for the vacuum. Paper Feed Speed The following table shows - Epson ColorWorks CW-C4000 | Designer s Guide for the Paper Feeder/Paper Rewinder - Page 8
Paper Load The allowable values of tension (F1, F2) applied to paper between the printer and a paper feeder or rewinder (or backing paper rewinder) are as follows. Paper rewinder Paper feeder Paper feeder side Paper (backing paper) rewinder side Paper tension (F1) Amplitude Paper tension (F2) - Epson ColorWorks CW-C4000 | Designer s Guide for the Paper Feeder/Paper Rewinder - Page 9
Paper Angle for Feeding and Ejecting The allowable values of angle for feeding paper from a paper feeder (θ1) and for ejecting paper to a paper rewinder (θ2) are as follows. Paper on feeder side Paper on rewinder side Angle for paper feeding: Θ1 Angle for ejecting paper: Θ2 0° When r1 > 1 inch: - Epson ColorWorks CW-C4000 | Designer s Guide for the Paper Feeder/Paper Rewinder - Page 10
Locations of Holes on the Bottom Case There are holes in the bottom case of the printer as shown in the figures below. They can be used as necessary for positioning the printer, etc. Note that the dimensions shown in the figures are for reference only. Printer Front Printer Rear 3.4 or greater (Min
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
 |
 |
Paper Feeder/Paper Rewinder
Designer's Guide
M00144300EN
Rev.A